[U-Boot] [RESEND PATCH v7 08/10] ls1088a: ddr: configure DDR for 0.9v for VID support

[Rajesh Bhagat]

When VID feature is supported, check the contents of fuse register
and configure DDR operate at 0.9v.

Signed-off-by: Ashish Kumar <Ashish.Kumar at nxp.com>
Signed-off-by: Rajesh Bhagat <rajesh.bhagat at nxp.com>
---
 board/freescale/ls1088a/ddr.c | 21 +++++++++++++++++++++
 1 file changed, 21 insertions(+)

diff --git a/board/freescale/ls1088a/ddr.c b/board/freescale/ls1088a/ddr.c
index e24bfd5..f3e70b5 100644
--- a/board/freescale/ls1088a/ddr.c
+++ b/board/freescale/ls1088a/ddr.c
@@ -13,6 +13,23 @@
 
 DECLARE_GLOBAL_DATA_PTR;
 
+#if defined(CONFIG_VID) && (!defined(CONFIG_SPL) || defined(CONFIG_SPL_BUILD))
+void fsl_ddr_setup_0v9_volt(memctl_options_t *popts)
+{
+	int vdd;
+
+	vdd = get_core_volt_from_fuse();
+	/* Nothing to do for silicons doesn't support VID */
+	if (vdd < 0)
+		return;
+
+	if (vdd == 900) {
+		popts->ddr_cdr1 |= DDR_CDR1_V0PT9_EN;
+		printf("VID: configure DDR to support 900 mV\n");
+	}
+}
+#endif
+
 void fsl_ddr_board_options(memctl_options_t *popts,
 			   dimm_params_t *pdimm,
 			   unsigned int ctrl_num)
@@ -87,6 +104,10 @@ found:
 	popts->addr_hash = 1;
 
 	popts->ddr_cdr1 = DDR_CDR1_DHC_EN | DDR_CDR1_ODT(DDR_CDR_ODT_60ohm);
+#if defined(CONFIG_VID) && (!defined(CONFIG_SPL) || defined(CONFIG_SPL_BUILD))
+	fsl_ddr_setup_0v9_volt(popts);
+#endif
+
 	popts->ddr_cdr2 = DDR_CDR2_ODT(DDR_CDR_ODT_60ohm) |
 			  DDR_CDR2_VREF_TRAIN_EN | DDR_CDR2_VREF_RANGE_2;
 }
-- 
2.7.4