[U-Boot] [PATCH v3 2/2] imx_common: detect USB serial downloader reliably

[Stefano Babic]

On 13/09/2017 23:29, Stefan Agner wrote:
> From: Stefan Agner <stefan.agner at toradex.com>
> 
> The current mechanism using SCR/GPR registers work well when
> the serial downloader boot mode has been selected explicitly
> (either via boot mode pins or using bmode command). However,
> in case the system entered boot ROM due to unbootable primary
> boot devices (e.g. empty eMMC), the SPL fails to detect that
> it has been downloaded through serial loader and tries to
> continue booting from eMMC:
>   Trying to boot from MMC1
>   mmc_load_image_raw_sector: mmc block read error
>   SPL: failed to boot from all boot devices
>   ### ERROR ### Please RESET the board ###
> 
> The only known way to reliably detect USB serial downloader
> is by checking the USB PHY receiver block power state...
> 
> Signed-off-by: Stefan Agner <stefan.agner at toradex.com>
> Acked-by: Marcel Ziswiler <marcel.ziswiler at toradex.com>
> Tested-by: Fabio Estevam <fabio.estevam at nxp.com>
> ---


Applied to u-boot-imx, thanks !

Best regards,
Stefano Babic



-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================