[U-Boot] [PATCH] ARM: mvebu: handle unused DRAM banks with ECC enabled

[Chris Packham]

dram_ecc_scrubbing() had code to skip unused DRAM banks but it would not
work because mvebu_sdram_bs() returns 0 and the code was subtracting 1
before checking the size. Remove the -1 from the bank size and the +1
from the total which will skip unused banks and still calculate the
correct size. Put the -1 where it is needed for scrubbing via the xor
engine.

Reported-by: Joshua Scott <joshua.scott at alliedtelesis.co.nz>
Signed-off-by: Chris Packham <judge.packham at gmail.com>
---

 arch/arm/mach-mvebu/dram.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/arch/arm/mach-mvebu/dram.c b/arch/arm/mach-mvebu/dram.c
index e3f304c366..f946c0cffe 100644
--- a/arch/arm/mach-mvebu/dram.c
+++ b/arch/arm/mach-mvebu/dram.c
@@ -179,11 +179,11 @@ static void dram_ecc_scrubbing(void)
 	reg_write(REG_SDRAM_CONFIG_ADDR, temp);
 
 	for (cs = 0; cs < CONFIG_NR_DRAM_BANKS; cs++) {
-		size = mvebu_sdram_bs(cs) - 1;
+		size = mvebu_sdram_bs(cs);
 		if (size == 0)
 			continue;
 
-		total = (u64)size + 1;
+		total = (u64)size;
 		total_mem += (u32)(total / (1 << 30));
 		start_addr = 0;
 		mv_xor_init2(cs);
@@ -194,7 +194,7 @@ static void dram_ecc_scrubbing(void)
 			size -= start_addr;
 		}
 
-		mv_xor_mem_init(SCRB_XOR_CHAN, start_addr, size,
+		mv_xor_mem_init(SCRB_XOR_CHAN, start_addr, size - 1,
 				SCRUB_MAGIC, SCRUB_MAGIC);
 
 		/* Wait for previous transfer completion */
-- 
2.14.1