[U-Boot] [PATCH v2 0/5] mmc: omap_hsmmc: Add support for ADMA

[Jaehoon Chung]

Hi,

On 09/25/2017 11:15 AM, Simon Glass wrote:
> Hi,
> 
> On 22 September 2017 at 08:20, Jaehoon Chung <jh80.chung at samsung.com> wrote:
>> On 09/21/2017 11:51 PM, Jean-Jacques Hiblot wrote:
>>> This series enables the ADMA present in some OMAP SOCs.
>>> On a DRA7 the performances when reading from the eMMC go from 18MB/s
>>> to 43MB/s.
>>> Also while were at it, fix some incorrect bit operations
>>>
>>> This series applies on top of the series that enables HS200 and UHS mode
>>> "mmc: Add support for HS200 and UHS modes" but should be easy to use on top
>>> of u-boot/master (just remove special handling of the tuning).
>>>
>>> This is the first series of 3 which wille enable HS200 and UHS on the omap5
>>> platforms (dra7 and am57).
>>
>> I didn't have omap board...Can someone check this patchset with omap?
>> Then it's more clearly.
> 
> Possibly, but it should not hold up the series being applied IMO.
> People tend to test mainline and it's good to apply these sorts of
> things during the merge window so that problems are found during the
> RC period.

This patch is depended on "HS200 an UHS modes" patches..
but i have replied with the some comment for them..so i will not apply this patches before applying them.

Best Regards,
Jaehoon Chung

> 
> Regards,
> Simon
> 
> 
>