[U-Boot] [PATCH 2/6] ARM: rmobile: Move HSUSB configuration to board on Salvator-X

[Marek Vasut]

In order to use ehci-generic driver, move the configuration of HSUSB
block into the board file. This configuration should not have been in
the Gen3 EHCI USB driver in the first place, so move it to the board
file until there is a proper infrastructure and driver for the HSUSB
block.

Signed-off-by: Marek Vasut <marek.vasut+renesas at gmail.com>
Cc: Nobuhiro Iwamatsu <iwamatsu at nigauri.org>
---
 board/renesas/salvator-x/salvator-x.c | 16 ++++++++++++++++
 1 file changed, 16 insertions(+)

diff --git a/board/renesas/salvator-x/salvator-x.c b/board/renesas/salvator-x/salvator-x.c
index e260117802..37fcbbd448 100644
--- a/board/renesas/salvator-x/salvator-x.c
+++ b/board/renesas/salvator-x/salvator-x.c
@@ -55,6 +55,7 @@ void s_init(void)
 #define SD1_MSTP313		BIT(13)
 #define SD2_MSTP312		BIT(12)	/* either MMC0 */
 #define SD3_MSTP311		BIT(11)	/* either MMC1 */
+#define HSUSB_MSTP704		BIT(4)	/* HSUSB */
 
 #define SD0CKCR			0xE6150074
 #define SD1CKCR			0xE6150078
@@ -92,6 +93,13 @@ int board_early_init_f(void)
 /* -/W 32 Power resume control register 2 (3DG) */
 #define	SYSC_PWRONCR2	0xE618010C
 
+/* HSUSB block registers */
+#define HSUSB_REG_LPSTS			0xE6590102
+#define HSUSB_REG_LPSTS_SUSPM_NORMAL	BIT(14)
+#define HSUSB_REG_UGCTRL2		0xE6590184
+#define HSUSB_REG_UGCTRL2_USB0SEL	0x30
+#define HSUSB_REG_UGCTRL2_USB0SEL_EHCI	0x10
+
 int board_init(void)
 {
 	/* adress of boot parameters */
@@ -116,6 +124,14 @@ int board_init(void)
 	/* USB1 pull-up */
 	setbits_le32(PFC_PUEN6, PUEN_USB1_OVC | PUEN_USB1_PWEN);
 
+	/* Configure the HSUSB block */
+	mstp_clrbits_le32(MSTPSR7, SMSTPCR7, HSUSB_MSTP704);
+	/* Choice USB0SEL */
+	clrsetbits_le32(HSUSB_REG_UGCTRL2, HSUSB_REG_UGCTRL2_USB0SEL,
+			HSUSB_REG_UGCTRL2_USB0SEL_EHCI);
+	/* low power status */
+	setbits_le16(HSUSB_REG_LPSTS, HSUSB_REG_LPSTS_SUSPM_NORMAL);
+
 #ifdef CONFIG_RENESAS_RAVB
 	/* EtherAVB Enable */
 	/* GPSR2 */
-- 
2.11.0