[U-Boot] [PATCH] tools/imximage: Fix fruity lack of 0x prefix in DCD Blocks

[Fabio Estevam]

On Mon, Apr 23, 2018 at 3:35 PM, Bryan O'Donoghue
<bryan.odonoghue at linaro.org> wrote:
> commit 8519c9c98ad6 ("tools/imximage: use 0x prefix in HAB Blocks line")
> adds an 0x prefix to each HAB Block number to make it easier for host tools
> to process the HAB Block output, however it neglects to apply the same
> prefix to the DCD Blocks directive. You need the DCD Blocks directive if
> you are making a u-boot recovery image which the BootROM will accept via
> the USB upload utility.
>
> This disparity results in a fruity output like this with HAB Blocks
> prefixed but DCD Blocks not prefixed - which is pretty inconsistent.
>
> This patch fixes the difference assuming the original commit was a
> legitimate change.
>
> Old:
> Image Type:   Freescale IMX Boot Image
> Image Ver:    2 (i.MX53/6/7 compatible)
> Mode:         DCD
> Data Size:    430080 Bytes = 420.00 KiB = 0.41 MiB
> Load Address: 877ff420
> Entry Point:  87800000
> HAB Blocks:   0x877ff400 0x00000000 0x00066c00
> DCD Blocks:   00910000 0000002c 000001d4
>
> New:
> Image Type:   Freescale IMX Boot Image
> Image Ver:    2 (i.MX53/6/7 compatible)
> Mode:         DCD
> Data Size:    430080 Bytes = 420.00 KiB = 0.41 MiB
> Load Address: 877ff420
> Entry Point:  87800000
> HAB Blocks:   0x877ff400 0x00000000 0x00066c00
> DCD Blocks:   0x00910000 0x0000002c 0x000001d4
>
> Signed-off-by: Bryan O'Donoghue <bryan.odonoghue at linaro.org>
> Cc: Rasmus Villemoes <rasmus.villemoes at prevas.dk>
> Cc: Fabio Estevam <fabio.estevam at nxp.com>
> Cc: Breno Lima <breno.lima at nxp.com>

I am all for consistency :-)

Reviewed-by: Fabio Estevam <fabio.estevam at nxp.com>