[U-Boot] [UBOOT PATCH v3 0/7] Add support of SD3.0 UHS modes for ZynqMP

[Michal Simek]

Dne po, 30. dub 2018 16:22 uživatel Tom Rini <trini at konsulko.com> napsal:

> On Mon, Apr 30, 2018 at 11:02:24AM +0200, Michal Simek wrote:
> > Hi Tom,
> >
> > On 19.4.2018 09:07, Siva Durga Prasad Paladugu wrote:
> > > This patch series is meant to add SD3.0 support for ZynqMP
> > > platform.
> > > The first five patches in the series mostly setting up
> > > things in sdhci layer to support SD3.0 , the sixth patch
> > > is to add SD3.0 support for ZynqMP platform and the last
> > > patch is to enable this support for ZynqMP zcu102 rev1.0
> > > eval board.
> > >
> > > Siva Durga Prasad Paladugu (7):
> > >   mmc: sdhci: Add support for disabling clock
> > >   mmc: sdhci: Handle execute tuning command in sdhci_send_command
> > >   sdhci: Add new sdhci ops for platform specific tuning and delays
> > >   mmc: sdhci: Invoke platform specific tuning and delay routines
> > >   mmc : sdhci: Read capabilities register1 and update host caps
> > >   mmc: zynq_sdhci: Add support for SD3.0
> > >   zynqmp: zcu102: Enable UHS support for ZCU102 Rev1.0 board
> > >
> > >  board/xilinx/zynqmp/Makefile                  |   2 +
> > >  board/xilinx/zynqmp/tap_delays.c              | 229
> +++++++++++++++++++++++++
> > >  configs/xilinx_zynqmp_zcu102_rev1_0_defconfig |   2 +
> > >  drivers/mmc/sdhci.c                           |  63 ++++++-
> > >  drivers/mmc/zynq_sdhci.c                      | 231
> +++++++++++++++++++++++++-
> > >  include/sdhci.h                               |   8 +
> > >  include/zynqmp_tap_delay.h                    |  20 +++
> > >  7 files changed, 547 insertions(+), 8 deletions(-)
> > >  create mode 100644 board/xilinx/zynqmp/tap_delays.c
> > >  create mode 100644 include/zynqmp_tap_delay.h
> > >
> >
> > It looks like that Jaehoon is out or busy with something else. Can you
> > please recommend someone to take a look at these patches? Definitely
> > feel free to look at it self.
>
> Are these things that need to come in for v2018.05 to fix regressions or
> new support?  Thanks!
>


New support.

Thanks,
Michal