[U-Boot] [linux-sunxi] [PATCH v2 00/13] Allwinner H6 support (w/ SPL)

[Icenowy Zheng]

在 2018-07-31二的 11:30 +0530，Jagan Teki写道：
> On Sat, Jul 21, 2018 at 1:50 PM, Icenowy Zheng <icenowy at aosc.io>
> wrote:
> > This patchset trys to add support for Allwinner H6 SoC to U-Boot.
> > 
> > Allwinner H6 is a quite new Allwinner SoC, with several parts
> > changed a
> > lot (memory map, DRAM controller, CCU, so on). The position which
> > SPL
> > will be loaded (SRAM A1) also changed to 0x20000.
> > 
> > The Pine H64 board support comes with this patchset, as this is the
> > first H6 board that I can get (being early bird).
> > 
> > Icenowy Zheng (13):
> >   sunxi: change SUNXI_HIGH_SRAM option to SUNXI_SRAM_ADDRESS
> >   sunxi: add basic memory map definitions of H6 SoC
> >   sunxi: change RMR64's RVBAR address for H6
> >   sunxi: change ATF position for H6
> >   sunxi: add config for SPL at 0x20000 on H6
> >   sunxi: change GIC address on H6
> >   sunxi: add clock code for H6
> >   sunxi: use sun6i-style watchdog for H6
> >   sunxi: add UART0 setup for H6
> >   sunxi: add MMC support for H6
> >   sunxi: add DRAM support to H6
> 
> Replaced with v2.1 [3]
> 
> >   sunxi: add support for Allwinner H6 SoC
> >   sunxi: add support for Pine H64 board
> 
> Applied to u-boot-sunxi/master
> 
> [3] https://patchwork.ozlabs.org/patch/947557/

I tried to build 89a897fc4d ("board: sun50i: h6: Add OrangePi One Plus
initial support"), and with GCC 7.3.0 and binutils 2.3.0 I got "region
`.sram' overflowed by 56 bytes".

> 
> Jagan.