[U-Boot] [PATCH] ARM: mach-omap2: Don't initialize I2C if DM_I2C is enabled

[Adam Ford]

boot-common.c checks to see if I2C is enabled in SPL, but
it doens't check for DM_I2C before initializing it.  This
will now only initialize the I2C is the DM_I2C is not enabled
to avoid initializing it more than once.

Signed-off-by: Adam Ford <aford173 at gmail.com>

diff --git a/arch/arm/mach-omap2/boot-common.c b/arch/arm/mach-omap2/boot-common.c
index d4a1e2e42c..176d4f67cb 100644
--- a/arch/arm/mach-omap2/boot-common.c
+++ b/arch/arm/mach-omap2/boot-common.c
@@ -202,7 +202,7 @@ void spl_board_init(void)
 #if defined(CONFIG_SPL_NAND_SUPPORT) || defined(CONFIG_SPL_ONENAND_SUPPORT)
 	gpmc_init();
 #endif
-#ifdef CONFIG_SPL_I2C_SUPPORT
+#if defined(CONFIG_SPL_I2C_SUPPORT) && !defined(CONFIG_DM_I2C)
 	i2c_init(CONFIG_SYS_OMAP24_I2C_SPEED, CONFIG_SYS_OMAP24_I2C_SLAVE);
 #endif
 #if defined(CONFIG_AM33XX) && defined(CONFIG_SPL_MUSB_NEW_SUPPORT)
-- 
2.17.1