[U-Boot] [PATCH v7 3/3] common: Generic firmware loader for file system

Marek Vasut marex at denx.de
Thu Feb 1 09:16:39 UTC 2018


On 02/01/2018 08:06 AM, Chee, Tien Fong wrote:
> On Tue, 2018-01-30 at 13:12 +0100, Marek Vasut wrote:
>> On 01/30/2018 12:16 PM, tien.fong.chee at intel.com wrote:
>>>
>>> From: Tien Fong Chee <tien.fong.chee at intel.com>
>>>
>>> This is file system generic loader which can be used to load
>>> the file image from the storage into target such as memory.
>>> The consumer driver would then use this loader to program whatever,
>>> ie. the FPGA device.
>>>
>>> Signed-off-by: Tien Fong Chee <tien.fong.chee at intel.com>
>>> Reviewed-by: Lothar Waßmann <LW at KARO-electronics.de>
>>> ---
>>>  common/Kconfig             |   9 ++
>>>  common/Makefile            |   1 +
>>>  common/fs_loader.c         | 326
>>> +++++++++++++++++++++++++++++++++++++++++++++
>>>  doc/README.firmware_loader |  76 +++++++++++
>>>  include/fs_loader.h        |  28 ++++
>>>  5 files changed, 440 insertions(+)
>>>  create mode 100644 common/fs_loader.c
>>>  create mode 100644 doc/README.firmware_loader
>>>  create mode 100644 include/fs_loader.h
>> [...]
>>
>>>
>>> +#ifdef CONFIG_CMD_UBIFS
>>> +static int mount_ubifs(struct device_location *location)
>>> +{
>>> +	int ret;
>>> +	char cmd[32];
>>> +
>>> +	snprintf(cmd, sizeof(location->mtdpart), "ubi part %s",
>>> +		 location->mtdpart);
>>> +
>>> +	ret = run_command(cmd, 0);
>> Can you call the UBI functions directly instead of invoking the U-
>> Boot
>> command parser ?
>>
> Okay.
>>>
>>> +	if (ret)
>>> +		return ret;
>>> +
>>> +	snprintf(cmd, sizeof(location->ubivol), "ubifsmount %s",
>>> +		 location->ubivol);
>>> +
>>> +	ret = run_command(cmd, 0);
>> DTTO here ...
>>
> Okay.
> 
> Could i submit the next version immediately for this minor change?

Wait a bit for some further feedback. Also make sure to go through the
patchset one more time and see if there aren't any similar mistakes.

-- 
Best regards,
Marek Vasut


More information about the U-Boot mailing list