[U-Boot] [PATCH 1/3] sunxi: Add selective PHY address

[Stefan Mavrodiev]

By default PHY address used for sunxi boards is 1. Some new boards
(A20-SOM204-EVB) uses different address.

The code enables selective PHY address via menuconfig inside ARM
submenu. The option has default value of 1.

Signed-off-by: Stefan Mavrodiev <stefan at olimex.com>
---
 arch/arm/mach-sunxi/Kconfig    | 9 +++++++++
 include/configs/sunxi-common.h | 4 ++--
 2 files changed, 11 insertions(+), 2 deletions(-)

diff --git a/arch/arm/mach-sunxi/Kconfig b/arch/arm/mach-sunxi/Kconfig
index 1fededd..034c2fd 100644
--- a/arch/arm/mach-sunxi/Kconfig
+++ b/arch/arm/mach-sunxi/Kconfig
@@ -838,6 +838,15 @@ config GMAC_TX_DELAY
 	---help---
 	Set the GMAC Transmit Clock Delay Chain value.
 
+config SUNXI_PHY_ADDR
+	int "PHY address"
+	default 1
+	depends on SUN7I_GMAC
+	---help---
+	The default PHY address for SUNXI is 1. Change this if your PHY
+	is configured with different address.
+
+
 config SPL_STACK_R_ADDR
 	default 0x4fe00000 if MACH_SUN4I
 	default 0x4fe00000 if MACH_SUN5I
diff --git a/include/configs/sunxi-common.h b/include/configs/sunxi-common.h
index ee1cb39..fd68d2b 100644
--- a/include/configs/sunxi-common.h
+++ b/include/configs/sunxi-common.h
@@ -288,12 +288,12 @@ extern int soft_i2c_gpio_scl;
 
 /* Ethernet support */
 #ifdef CONFIG_SUN4I_EMAC
-#define CONFIG_PHY_ADDR		1
+#define CONFIG_PHY_ADDR		CONFIG_SUNXI_PHY_ADDR
 #define CONFIG_MII			/* MII PHY management		*/
 #endif
 
 #ifdef CONFIG_SUN7I_GMAC
-#define CONFIG_PHY_ADDR		1
+#define CONFIG_PHY_ADDR		CONFIG_SUNXI_PHY_ADDR
 #define CONFIG_MII			/* MII PHY management		*/
 #define CONFIG_PHY_REALTEK
 #endif
-- 
2.7.4