[U-Boot] [PATCH v2 00/13] LS1012A PFE driver patch series

Calvin Johnson calvin.johnson at nxp.com
Thu Feb 15 16:44:11 UTC 2018


Hi York,

> -----Original Message-----
> From: York Sun
> Sent: Thursday, February 15, 2018 9:19 PM
> To: Calvin Johnson <calvin.johnson at nxp.com>; u-boot at lists.denx.de
> Cc: joe.hershberger at ni.com; Anji Jagarlmudi <anji.jagarlmudi at nxp.com>
> Subject: Re: [PATCH v2 00/13] LS1012A PFE driver patch series
> 
> On 02/15/2018 06:10 AM, Calvin Johnson wrote:
> > Hi,
> >
> > This patch series introduces U-Boot support for NXP's LS1012A Packet
> > Forwarding Engine (pfe_eth). LS1012A uses hardware packet forwarding
> > engine to provide high performance Ethernet interfaces. The device
> > includes two Ethernet ports.
> >
> > Changes in v2 series:
> > 1. PFE patches submitted on top of this base patch are now merged to
> > this patch.
> > 2. Platform changes are segregated into different patches.
> > 3. Network enabled on 2g5rdb platform
> > 4. Moved from legacy to new driver model.
> >
> > Calvin Johnson (12):
> >   drivers: net: phy: Fix aquantia compilation with DM
> >   drivers: net: pfe_eth: LS1012A PFE driver introduction
> >   drivers: net: pfe_eth: provide pfe commands
> >   drivers: net: pfe_eth: LS1012A PFE headers
> >   board: freescale: ls1012aqds: enable network support on ls1012aqds
> >   board: freescale: ls1012afrdm: enable network support on ls1012afrdm
> >   board: freescale: ls1012ardb: enable network support on ls1012ardb
> >   board: freescale: ls1012a2g5rdb: enable network support on
> >     ls1012a2g5rdb
> >   armv8: fsl-lsch2: add pfe macros and update ccsr_scfg structure
> >   armv8: fsl-lsch2: configure pfe's DDR and HDBUS interfaces and ECC
> >   armv8: layerscape: csu: enable ns access to PFE registers
> >   configs: ls1012a: add pfe configuration for LS1012A
> >
> > Prabhakar Kushwaha (1):
> >   armv8: fsl-layerscape: Add support of GPIO structure
> 
> Calvin,
> 
> I think you should update your copyright year. Is it right to add
> 2015-2016 copyright year? Did you have these files then?

I think most of the pfe driver files, except for board files were present 
during that period. 

However, I would wait for Anji to respond on this. Based on his response
I can update copyright year if required.

Thanks
Calvin


More information about the U-Boot mailing list