[U-Boot] [PATCH 1/5] imx: hab: Keep CAAM clock enabled after authenticating additional images

[Breno Lima]

From: Breno Lima <breno.lima at nxp.com>

Currently it is not possible to run CMD_DEK on i.MX SPL targets:

=> dek_blob 0x12000000 0x12001000 128

The system hangs after running dek_blob because the CAAM clock is being
disabled by the HAB code. There is no need to disable CAAM clock after
authenticating additional boot images, thus keep CAAM clock enabled to
address this issue.

Signed-off-by: Breno Lima <breno.lima at nxp.com>
---
 arch/arm/mach-imx/hab.c | 7 +++----
 1 file changed, 3 insertions(+), 4 deletions(-)

diff --git a/arch/arm/mach-imx/hab.c b/arch/arm/mach-imx/hab.c
index 5f19777..1e6b31d 100644
--- a/arch/arm/mach-imx/hab.c
+++ b/arch/arm/mach-imx/hab.c
@@ -507,13 +507,13 @@ int imx_hab_authenticate_image(uint32_t ddr_start, uint32_t image_size,
 
 	/* Verify IVT header bugging out on error */
 	if (verify_ivt_header(ivt_hdr))
-		goto hab_caam_clock_disable;
+		goto hab_authentication_exit;
 
 	/* Verify IVT body */
 	if (ivt->self != ivt_addr) {
 		printf("ivt->self 0x%08x pointer is 0x%08x\n",
 		       ivt->self, ivt_addr);
-		goto hab_caam_clock_disable;
+		goto hab_authentication_exit;
 	}
 
 	start = ddr_start;
@@ -591,8 +591,7 @@ hab_exit_failure_print_status:
 	get_hab_status();
 #endif
 
-hab_caam_clock_disable:
-	hab_caam_clock_enable(0);
+hab_authentication_exit:
 
 	if (load_addr != 0)
 		result = 0;
-- 
2.7.4