[U-Boot] [RFC v2 10/15] bmips: enable f at st1704 enet support

[Álvaro Fernández Rojas]

Signed-off-by: Álvaro Fernández Rojas <noltari at gmail.com>
---
 v2: no changes

 arch/mips/dts/sagem,f at st1704.dts     | 12 ++++++++++++
 configs/sagem_f at st1704_ram_defconfig |  9 ++++++++-
 2 files changed, 20 insertions(+), 1 deletion(-)

diff --git a/arch/mips/dts/sagem,f at st1704.dts b/arch/mips/dts/sagem,f at st1704.dts
index dd0e5b8b7c..99d031f10a 100644
--- a/arch/mips/dts/sagem,f at st1704.dts
+++ b/arch/mips/dts/sagem,f at st1704.dts
@@ -40,6 +40,18 @@
 	};
 };
 
+&enet {
+	status = "okay";
+	phy = <&enetphy>;
+	phy-mode = "mii";
+
+	enetphy: fixed-link {
+		reg = <1>;
+		speed = <100>;
+		full-duplex;
+	};
+};
+
 &gpio {
 	status = "okay";
 };
diff --git a/configs/sagem_f at st1704_ram_defconfig b/configs/sagem_f at st1704_ram_defconfig
index 0adcd46d51..1a640781b7 100644
--- a/configs/sagem_f at st1704_ram_defconfig
+++ b/configs/sagem_f at st1704_ram_defconfig
@@ -28,11 +28,15 @@ CONFIG_CMD_MEMINFO=y
 # CONFIG_CMD_LOADS is not set
 CONFIG_CMD_SF=y
 CONFIG_CMD_SPI=y
-# CONFIG_CMD_NET is not set
+CONFIG_CMD_DHCP=y
 # CONFIG_CMD_NFS is not set
+CONFIG_CMD_MII=y
+CONFIG_CMD_PING=y
 # CONFIG_CMD_MISC is not set
 CONFIG_OF_EMBED=y
+CONFIG_NET_RANDOM_ETHADDR=y
 # CONFIG_DM_DEVICE_REMOVE is not set
+CONFIG_BCM6348_IUDMA=y
 CONFIG_DM_GPIO=y
 CONFIG_BCM6345_GPIO=y
 CONFIG_LED=y
@@ -41,6 +45,9 @@ CONFIG_DM_SPI_FLASH=y
 CONFIG_SPI_FLASH=y
 CONFIG_SPI_FLASH_WINBOND=y
 CONFIG_SPI_FLASH_MTD=y
+CONFIG_PHY_FIXED=y
+CONFIG_DM_ETH=y
+CONFIG_BCM6348_ETH=y
 CONFIG_DM_RESET=y
 CONFIG_RESET_BCM6345=y
 # CONFIG_SPL_SERIAL_PRESENT is not set
-- 
2.11.0