[U-Boot] [PATCH v2 2/3] arm: zynq: Wire watchdog internals

[Michal Simek]

Watchdog is only enabled in full u-boot. Adoption for SPL should be also
done because that's the right place where watchdog should be enabled.

Signed-off-by: Michal Simek <michal.simek at xilinx.com>
---

Changes in v2:
- Make watchdog_reset depends on CONFIG_WATCHDOG not WDT
  This will handle use cases where watchdog is cleared by OS

 arch/arm/Kconfig          |  1 +
 board/xilinx/zynq/board.c | 49 +++++++++++++++++++++++++++++++++++++++++++++++
 2 files changed, 50 insertions(+)

diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig
index 2c52ff025a22..a66d04eadfcb 100644
--- a/arch/arm/Kconfig
+++ b/arch/arm/Kconfig
@@ -761,6 +761,7 @@ config ARCH_ZYNQ
 	select SUPPORT_SPL
 	select OF_CONTROL
 	select SPL_BOARD_INIT if SPL
+	select BOARD_EARLY_INIT_F if WDT
 	select SPL_OF_CONTROL if SPL
 	select DM
 	select DM_ETH if NET
diff --git a/board/xilinx/zynq/board.c b/board/xilinx/zynq/board.c
index fb8eab07d768..838ac0f4c4ea 100644
--- a/board/xilinx/zynq/board.c
+++ b/board/xilinx/zynq/board.c
@@ -6,9 +6,11 @@
  */
 
 #include <common.h>
+#include <dm/uclass.h>
 #include <fdtdec.h>
 #include <fpga.h>
 #include <mmc.h>
+#include <wdt.h>
 #include <zynqpl.h>
 #include <asm/arch/hardware.h>
 #include <asm/arch/sys_proto.h>
@@ -33,6 +35,22 @@ static xilinx_desc fpga045 = XILINX_XC7Z045_DESC(0x45);
 static xilinx_desc fpga100 = XILINX_XC7Z100_DESC(0x100);
 #endif
 
+#if !defined(CONFIG_SPL_BUILD) && defined(CONFIG_WDT)
+static struct udevice *watchdog_dev;
+#endif
+
+#if !defined(CONFIG_SPL_BUILD) && defined(CONFIG_BOARD_EARLY_INIT_F)
+int board_early_init_f(void)
+{
+# if defined(CONFIG_WDT)
+	/* bss is not cleared at time when watchdog_reset() is called */
+	watchdog_dev = NULL;
+# endif
+
+	return 0;
+}
+#endif
+
 int board_init(void)
 {
 #if (defined(CONFIG_FPGA) && !defined(CONFIG_SPL_BUILD)) || \
@@ -75,6 +93,15 @@ int board_init(void)
 	}
 #endif
 
+#if !defined(CONFIG_SPL_BUILD) && defined(CONFIG_WDT)
+	if (uclass_get_device(UCLASS_WDT, 0, &watchdog_dev)) {
+		puts("Watchdog: Not found!\n");
+	} else {
+		wdt_start(watchdog_dev, 0, 0);
+		puts("Watchdog: Started\n");
+	}
+# endif
+
 #if (defined(CONFIG_FPGA) && !defined(CONFIG_SPL_BUILD)) || \
     (defined(CONFIG_SPL_FPGA_SUPPORT) && defined(CONFIG_SPL_BUILD))
 	fpga_init();
@@ -164,3 +191,25 @@ int dram_init(void)
 	return 0;
 }
 #endif
+
+#if defined(CONFIG_WATCHDOG)
+/* Called by macro WATCHDOG_RESET */
+void watchdog_reset(void)
+{
+# if !defined(CONFIG_SPL_BUILD)
+	static ulong next_reset;
+	ulong now;
+
+	if (!watchdog_dev)
+		return;
+
+	now = timer_get_us();
+
+	/* Do not reset the watchdog too often */
+	if (now > next_reset) {
+		wdt_reset(watchdog_dev);
+		next_reset = now + 1000;
+	}
+# endif
+}
+#endif
-- 
1.9.1