[U-Boot] [PATCH 0/2] arm: zynq: add support for the zybo z7 board

[Luis Araneda]

Hi,

On Fri, Jul 13, 2018 at 11:45 AM Luis Araneda <luaraneda at gmail.com> wrote:
> This series adds support for the Digilent Zybo Z7 board
>
> The only think, that I tested, and is not working yet, is reading the
> MAC address from the OTP region of the SPI flash memory, but I pretend
> to work on that
> [...]

Ping. I'd like to get this reviewed, and hopefully merged, before v2018.09.

Also, I'd like an opinion/comments on something related to the board.
The board has two variants, "Zybo Z7-10" and "Zybo Z7-20". The
differences between them are the SoC (XC7Z010 vs XC7Z020) and some
components (RGB LEDs, HDMI CEC support, GPIO port) connected to the
FPGA fabric. Currently, there's only one device-tree for both variants
on Linux, which I think is fine because the differences between them
are components connected to the FPGA fabric.

Should the variants have separate defconfig files? I need to know at
compile time the variant to include the correct FPGA bitstream (fit
image). So I think two defconfig files are necessary.

Maybe, even though from a device-tree perspective the variants are the
same, each variant should have a device-tree file because they are
physically different boards. What do you think?

Thanks,

Luis Araneda.