[U-Boot] [PATCH 2/2] arm: zynq: add support for the zybo z7 board

[Luis Araneda]

Hi Michal,

On Fri, Jul 20, 2018 at 3:09 AM Michal Simek <monstr at monstr.eu> wrote:
> On 13.7.2018 17:44, Luis Araneda wrote:
> > [...]
> > +CONFIG_DM_I2C=y
> > +CONFIG_SYS_I2C_CADENCE=y
> > +CONFIG_MMC_SDHCI=y
> > +CONFIG_MMC_SDHCI_ZYNQ=y
> > +CONFIG_SPI_FLASH=y
> > +CONFIG_SPI_FLASH_BAR=y
> > +CONFIG_SPI_FLASH_SPANSION=y
> > +CONFIG_PHY_REALTEK=y
> > +CONFIG_ZYNQ_GEM=y
> > +CONFIG_DEBUG_UART_ZYNQ=y
> > +CONFIG_ZYNQ_SERIAL=y
> > +CONFIG_ZYNQ_QSPI=y
> > +CONFIG_USB=y
> > +CONFIG_USB_EHCI_HCD=y
> > +CONFIG_USB_ULPI_VIEWPORT=y
> > +CONFIG_USB_ULPI=y
> > +CONFIG_USB_STORAGE=y
> > +CONFIG_USB_GADGET=y
> > +CONFIG_USB_GADGET_MANUFACTURER="Xilinx"
> > +CONFIG_USB_GADGET_VENDOR_NUM=0x03fd
> > +CONFIG_USB_GADGET_PRODUCT_NUM=0x0300
> > +CONFIG_CI_UDC=y
> > +CONFIG_USB_GADGET_DOWNLOAD=y
> > +CONFIG_USB_FUNCTION_THOR=y
> > +CONFIG_DISPLAY=y
>
> Not sure if make sense to enable this CONFIG_DISPLAY but the rest is fine.

Probably not, I selected it because the Zybo had it selected. I'll
remove it for v2.

Additionally, for v2 I'll will be using the zynq_i2c driver (not DM)
because the I2C peripherals on this board are connected like the Zybo.
For more details, refer to the reply of "[PATCH 4/4] arm: zynq: use
i2c cadence DM driver"


Thanks,

Luis Araneda.