[U-Boot] [linux-sunxi] [PATCH v2 00/13] Allwinner H6 support (w/ SPL)

[Jagan Teki]

On Sat, Jul 21, 2018 at 1:50 PM, Icenowy Zheng <icenowy at aosc.io> wrote:
> This patchset trys to add support for Allwinner H6 SoC to U-Boot.
>
> Allwinner H6 is a quite new Allwinner SoC, with several parts changed a
> lot (memory map, DRAM controller, CCU, so on). The position which SPL
> will be loaded (SRAM A1) also changed to 0x20000.
>
> The Pine H64 board support comes with this patchset, as this is the
> first H6 board that I can get (being early bird).
>
> Icenowy Zheng (13):
>   sunxi: change SUNXI_HIGH_SRAM option to SUNXI_SRAM_ADDRESS
>   sunxi: add basic memory map definitions of H6 SoC
>   sunxi: change RMR64's RVBAR address for H6
>   sunxi: change ATF position for H6
>   sunxi: add config for SPL at 0x20000 on H6
>   sunxi: change GIC address on H6
>   sunxi: add clock code for H6
>   sunxi: use sun6i-style watchdog for H6
>   sunxi: add UART0 setup for H6
>   sunxi: add MMC support for H6
>   sunxi: add DRAM support to H6
>   sunxi: add support for Allwinner H6 SoC
>   sunxi: add support for Pine H64 board

Observing SPL hang during relocation switch to board_init_r with
orangepi board[1], will pine boot? look like both seem similar LPDDR3
configs atleast from schematics.

U-Boot SPL 2018.07-00382-g2e8302784f-dirty (Jul 26 2018 - 12:13:35 +0530)
DRAM: 1024 MiB
sunxi_board_init...done!

[1] http://linux-sunxi.org/Xunlong_Orange_Pi_One_Plus