[U-Boot] [PATCHv2 1/2] dra7xx: Always enable UART1 and UART3 in early_padconf

[Lokesh Vutla]

On Wednesday 07 March 2018 05:32 AM, Tom Rini wrote:
> It is safe to always setup the pinmux for UART1 and UART3 to be used in
> early_padconf and then if these pins are needed later on, they will be
> re-muxed.  This allows us to drop the usage of CONFIG_CONS_INDEX here.

Reviewed-by: Lokesh Vutla <lokeshvutla at ti.com>

Thanks and regards,
Lokesh

> 
> Cc: Lokesh Vutla <lokeshvutla at ti.com>
> Signed-off-by: Tom Rini <trini at konsulko.com>
> ---
>  board/ti/dra7xx/mux_data.h | 3 ---
>  1 file changed, 3 deletions(-)
> 
> diff --git a/board/ti/dra7xx/mux_data.h b/board/ti/dra7xx/mux_data.h
> index b5dcaa584a24..32c9ecacce2a 100644
> --- a/board/ti/dra7xx/mux_data.h
> +++ b/board/ti/dra7xx/mux_data.h
> @@ -372,13 +372,10 @@ const struct pad_conf_entry dra71x_core_padconf_array[] = {
>  };
>  
>  const struct pad_conf_entry early_padconf[] = {
> -#if (CONFIG_CONS_INDEX == 1)
>  	{UART1_RXD, (PIN_INPUT_SLEW | M0)}, /* UART1_RXD */
>  	{UART1_TXD, (PIN_INPUT_SLEW | M0)}, /* UART1_TXD */
> -#elif (CONFIG_CONS_INDEX == 3)
>  	{UART3_RXD, (PIN_INPUT_SLEW | M0)}, /* UART3_RXD */
>  	{UART3_TXD, (PIN_INPUT_SLEW | M0)}, /* UART3_TXD */
> -#endif
>  	{I2C1_SDA, (PIN_INPUT | M0)},	/* I2C1_SDA */
>  	{I2C1_SCL, (PIN_INPUT | M0)},	/* I2C1_SCL */
>  };
>