[U-Boot] [PATCH 1/7] db820c: set clk node to be probed before relocation

[Simon Glass]

Hi Ramon,

On 12 May 2018 at 20:15, Ramon Fried <ramon.fried at gmail.com> wrote:
> The clock and serial nodes are needed before relocation.
> This patch ensures that the msm-serial driver will probe
> and provide uart output before relocation.
>
> Signed-off-by: Ramon Fried <ramon.fried at gmail.com>
> ---
>  arch/arm/dts/dragonboard820c-uboot.dtsi | 14 ++++++++++++++
>  1 file changed, 14 insertions(+)
>
> diff --git a/arch/arm/dts/dragonboard820c-uboot.dtsi b/arch/arm/dts/dragonboard820c-uboot.dtsi
> index 88312b3fa1..81df788fca 100644
> --- a/arch/arm/dts/dragonboard820c-uboot.dtsi
> +++ b/arch/arm/dts/dragonboard820c-uboot.dtsi
> @@ -5,6 +5,20 @@
>   * (C) Copyright 2017 Jorge Ramirez-Ortiz <jorge.ramirez-ortiz at linaro.org>
>   */
>
> +/ {
> +       soc {
> +               u-boot,dm-pre-reloc;
> +
> +       clock-controller at 300000 {

This line and a few below it should be indented one more stop.

> +               u-boot,dm-pre-reloc;
> +       };
> +
> +       serial at 75b0000 {
> +               u-boot,dm-pre-reloc;
> +               };
> +       };
> +};
> +
>  &pm8994_pon {
>         key_vol_down {
>                 gpios = <&pm8994_pon 1 0>;
> --
> 2.14.1
>

Regards,
Simon