[U-Boot] [PATCH v2] ehci: Replace board_prepare_usb with board_usb_init

[Ramon Fried]

On Sun, May 20, 2018 at 10:34 PM, Marek Vasut <marek.vasut at gmail.com> wrote:
> On 05/20/2018 09:15 PM, Ramon Fried wrote:
>> Use standard board_usb_init() instead of the specific board_prepare_usb.
>>
>> Signed-off-by: Ramon Fried <ramon.fried at gmail.com>
>> ---
>> v2: remove a line that sneaked in by mistake
>>  board/qualcomm/dragonboard410c/dragonboard410c.c | 4 ++--
>>  drivers/usb/host/ehci-msm.c                      | 9 ++-------
>>  2 files changed, 4 insertions(+), 9 deletions(-)
>>
>> diff --git a/board/qualcomm/dragonboard410c/dragonboard410c.c b/board/qualcomm/dragonboard410c/dragonboard410c.c
>> index e7ead57f0d..679eab759a 100644
>> --- a/board/qualcomm/dragonboard410c/dragonboard410c.c
>> +++ b/board/qualcomm/dragonboard410c/dragonboard410c.c
>> @@ -41,7 +41,7 @@ int dram_init_banksize(void)
>>       return 0;
>>  }
>>
>> -int board_prepare_usb(enum usb_init_type type)
>> +int board_usb_init(int index, enum usb_init_type init)
>>  {
>>       static struct udevice *pmic_gpio;
>>       static struct gpio_desc hub_reset, usb_sel;
>> @@ -90,7 +90,7 @@ int board_prepare_usb(enum usb_init_type type)
>>               }
>>       }
>>
>> -     if (type == USB_INIT_HOST) {
>> +     if (init == USB_INIT_HOST) {
>>               /* Start USB Hub */
>>               dm_gpio_set_dir_flags(&hub_reset,
>>                                     GPIOD_IS_OUT | GPIOD_IS_OUT_ACTIVE);
>
> Obvious question -- can this not be started by some regulator ? Then
> this board hook can go away altogether.
By regulator do you mean pinctrl framework ?
>
> [...]
>
> --
> Best regards,
> Marek Vasut