[U-Boot] [PATCH v3] fsl-lsch3: soc: Enable AHB read support for Flexspi controller

[Ashish Kumar]

> -----Original Message-----
> From: York Sun
> Sent: Tuesday, November 20, 2018 2:13 AM
> To: Ashish Kumar <ashish.kumar at nxp.com>; u-boot at lists.denx.de
> Cc: Yogesh Narayan Gaur <yogeshnarayan.gaur at nxp.com>; Rajat Srivastava
> <rajat.srivastava at nxp.com>
> Subject: Re: [PATCH v3] fsl-lsch3: soc: Enable AHB read support for Flexspi
> controller
> 
> On 11/12/18 11:26 PM, Ashish Kumar wrote:
> > Enable AHB support for Flexspi controller interface meaning memory can
> > be accessed via md command using absolute addresses
> >
> > Signed-off-by: Yogesh Gaur <yogeshnarayan.gaur at nxp.com>
> > Signed-off-by: Rajat Srivastava <rajat.srivastava at nxp.com>
> > Signed-off-by: Ashish Kumar <Ashish.Kumar at nxp.com>
> > ---
> > v3:
> > Depends upon http://patchwork.ozlabs.org/patch/975009/
Hi York,

Sorry that  was typo, it was meant to be http://patchwork.ozlabs.org/patch/974301/.
But unfortunately after lot of delay in review on NXP-FlexSPI driver, it has been asked to re-write to a new frame-work. I think I should defer this http://patchwork.ozlabs.org/patch/975008/ and http://patchwork.ozlabs.org/patch/996846/ for the time being until 974301 is re-written. What do you suggest?

Regards
Ashish
> 
> Your v3 patch depends on its v2 version. This doesn't make sense.
> 
> York