[U-Boot] [PATCH v3] fsl-lsch3: soc: Enable AHB read support for Flexspi controller

[York Sun]

On 11/20/18 1:24 AM, Ashish Kumar wrote:
> 
> 
>> -----Original Message-----
>> From: York Sun
>> Sent: Tuesday, November 20, 2018 2:13 AM
>> To: Ashish Kumar <ashish.kumar at nxp.com>; u-boot at lists.denx.de
>> Cc: Yogesh Narayan Gaur <yogeshnarayan.gaur at nxp.com>; Rajat Srivastava
>> <rajat.srivastava at nxp.com>
>> Subject: Re: [PATCH v3] fsl-lsch3: soc: Enable AHB read support for Flexspi
>> controller
>>
>> On 11/12/18 11:26 PM, Ashish Kumar wrote:
>>> Enable AHB support for Flexspi controller interface meaning memory can
>>> be accessed via md command using absolute addresses
>>>
>>> Signed-off-by: Yogesh Gaur <yogeshnarayan.gaur at nxp.com>
>>> Signed-off-by: Rajat Srivastava <rajat.srivastava at nxp.com>
>>> Signed-off-by: Ashish Kumar <Ashish.Kumar at nxp.com>
>>> ---
>>> v3:
>>> Depends upon http://patchwork.ozlabs.org/patch/975009/
> Hi York,
> 
> Sorry that  was typo, it was meant to be http://patchwork.ozlabs.org/patch/974301/.
> But unfortunately after lot of delay in review on NXP-FlexSPI driver, it has been asked to re-write to a new frame-work. I think I should defer this http://patchwork.ozlabs.org/patch/975008/ and http://patchwork.ozlabs.org/patch/996846/ for the time being until 974301 is re-written. What do you suggest?
> 

You still need FlexSPI driver, don't you? Please work with Jagan on the
driver.

York