[U-Boot] [PATCH v3 00/17] riscv: Add QEMU virt board support

[Auer, Lukas]

Hi Bin,

On Thu, 2018-10-04 at 15:01 +0800, Bin Meng wrote:
> Hi Lukas,
> 
> On Thu, Oct 4, 2018 at 12:45 AM Auer, Lukas
> <lukas.auer at aisec.fraunhofer.de> wrote:
> > 
> > Hi Bin,
> > 
> > On Wed, 2018-09-26 at 06:55 -0700, Bin Meng wrote:
> > > This series adds QEMU RISC-V 'virt' board target support, with
> > > the
> > > hope of helping people easily test U-Boot on RISC-V.
> > > 
> > > Some existing RISC-V codes have been changed to make it easily to
> > > support new targets. Some spotted coding style issues are fixed.
> > > 
> > > This series is available at u-boot-x86/riscv-working for testing.
> > > 
> > > Changes in v3:
> > > - net patch to print the relocation address in cmd 'bdinfo'
> > > - new patch to imply DM support for some common drivers
> > > - reword the reset message a little, and call hang() in the end
> > > 
> > > Changes in v2:
> > > - Change Linux kernel entry parameters' type to support 32/64 bit
> > > - new patch to remove CSR read/write defines in encoding.h
> > > - new patch to pass mhartid CSR value to kernel
> > > - new patch to move do_reset() to a common place
> > > 
> > 
> > One more thing, I wanted to let you know about. I am already able
> > to
> > boot Linux in QEMU with this patch series, and u-boot master now. I
> > had
> > to make minor changes to the board config / environment to enable
> > FIT
> > images, though jumping directly to bbl + Linux with 'go' should
> > work as
> > well.
> 
> Good to know.
> 
> > I did modify QEMU slightly so that it also loads binaries instead
> > of
> > just ELF files. I am planning to start sending my patches to u-boot 
> > and
> > QEMU next week.
> 
> Do you mean QEMU's -kernel parameter?
> 
> Regards,
> Bin

Yes. I also modified the -bios parameter, though that's not strictly
needed.

Thanks,
Lukas