[U-Boot] [PATCH v3 7/7] driver: net: ti: keystone_net: switch to use common mdio lib
Grygorii Strashko
grygorii.strashko at ti.com
Wed Oct 31 21:21:45 UTC 2018
Update TI Keystone 2 driver to re-use common mdio lib.
Reviewed-by: Tom Rini <trini at konsulko.com>
Acked-by: Joe Hershberger <joe.hershberger at ni.com>
Signed-off-by: Grygorii Strashko <grygorii.strashko at ti.com>
---
arch/arm/include/asm/ti-common/keystone_net.h | 13 ---
drivers/net/ti/Makefile | 2 +-
drivers/net/ti/keystone_net.c | 118 ++++----------------------
3 files changed, 18 insertions(+), 115 deletions(-)
diff --git a/arch/arm/include/asm/ti-common/keystone_net.h b/arch/arm/include/asm/ti-common/keystone_net.h
index bef1867..bba1048 100644
--- a/arch/arm/include/asm/ti-common/keystone_net.h
+++ b/arch/arm/include/asm/ti-common/keystone_net.h
@@ -57,19 +57,6 @@
/* MDIO clock output frequency */
#define EMAC_MDIO_CLOCK_FREQ 2500000 /* 2.5 MHz */
-/* MII Status Register */
-#define MII_STATUS_REG 1
-#define MII_STATUS_LINK_MASK 0x4
-
-#define MDIO_CONTROL_IDLE 0x80000000
-#define MDIO_CONTROL_ENABLE 0x40000000
-#define MDIO_CONTROL_FAULT_ENABLE 0x40000
-#define MDIO_CONTROL_FAULT 0x80000
-#define MDIO_USERACCESS0_GO 0x80000000
-#define MDIO_USERACCESS0_WRITE_READ 0x0
-#define MDIO_USERACCESS0_WRITE_WRITE 0x40000000
-#define MDIO_USERACCESS0_ACK 0x20000000
-
#define EMAC_MACCONTROL_MIIEN_ENABLE 0x20
#define EMAC_MACCONTROL_FULLDUPLEX_ENABLE 0x1
#define EMAC_MACCONTROL_GIGABIT_ENABLE BIT(7)
diff --git a/drivers/net/ti/Makefile b/drivers/net/ti/Makefile
index d2b6f20..ee3e4eb 100644
--- a/drivers/net/ti/Makefile
+++ b/drivers/net/ti/Makefile
@@ -4,4 +4,4 @@
obj-$(CONFIG_DRIVER_TI_CPSW) += cpsw.o cpsw-common.o cpsw_mdio.o
obj-$(CONFIG_DRIVER_TI_EMAC) += davinci_emac.o
-obj-$(CONFIG_DRIVER_TI_KEYSTONE_NET) += keystone_net.o
+obj-$(CONFIG_DRIVER_TI_KEYSTONE_NET) += keystone_net.o cpsw_mdio.o
diff --git a/drivers/net/ti/keystone_net.c b/drivers/net/ti/keystone_net.c
index 5550572..a3ba91c 100644
--- a/drivers/net/ti/keystone_net.c
+++ b/drivers/net/ti/keystone_net.c
@@ -22,6 +22,8 @@
#include <asm/ti-common/keystone_serdes.h>
#include <asm/arch/psc_defs.h>
+#include "cpsw_mdio.h"
+
DECLARE_GLOBAL_DATA_PTR;
#ifdef KEYSTONE2_EMAC_GIG_ENABLE
@@ -97,93 +99,20 @@ struct ks2_eth_priv {
bool has_mdio;
};
-/* MDIO */
-
-static int keystone2_mdio_reset(struct mii_dev *bus)
-{
- u_int32_t clkdiv;
- struct mdio_regs *adap_mdio = bus->priv;
-
- clkdiv = (EMAC_MDIO_BUS_FREQ / EMAC_MDIO_CLOCK_FREQ) - 1;
-
- writel((clkdiv & 0xffff) | MDIO_CONTROL_ENABLE |
- MDIO_CONTROL_FAULT | MDIO_CONTROL_FAULT_ENABLE,
- &adap_mdio->control);
-
- while (readl(&adap_mdio->control) & MDIO_CONTROL_IDLE)
- ;
-
- return 0;
-}
-
-/**
- * keystone2_mdio_read - read a PHY register via MDIO interface.
- * Blocks until operation is complete.
- */
-static int keystone2_mdio_read(struct mii_dev *bus,
- int addr, int devad, int reg)
-{
- int tmp;
- struct mdio_regs *adap_mdio = bus->priv;
-
- while (readl(&adap_mdio->useraccess0) & MDIO_USERACCESS0_GO)
- ;
-
- writel(MDIO_USERACCESS0_GO | MDIO_USERACCESS0_WRITE_READ |
- ((reg & 0x1f) << 21) | ((addr & 0x1f) << 16),
- &adap_mdio->useraccess0);
-
- /* Wait for command to complete */
- while ((tmp = readl(&adap_mdio->useraccess0)) & MDIO_USERACCESS0_GO)
- ;
-
- if (tmp & MDIO_USERACCESS0_ACK)
- return tmp & 0xffff;
-
- return -1;
-}
-
-/**
- * keystone2_mdio_write - write to a PHY register via MDIO interface.
- * Blocks until operation is complete.
- */
-static int keystone2_mdio_write(struct mii_dev *bus,
- int addr, int devad, int reg, u16 val)
-{
- struct mdio_regs *adap_mdio = bus->priv;
-
- while (readl(&adap_mdio->useraccess0) & MDIO_USERACCESS0_GO)
- ;
-
- writel(MDIO_USERACCESS0_GO | MDIO_USERACCESS0_WRITE_WRITE |
- ((reg & 0x1f) << 21) | ((addr & 0x1f) << 16) |
- (val & 0xffff), &adap_mdio->useraccess0);
-
- /* Wait for command to complete */
- while (readl(&adap_mdio->useraccess0) & MDIO_USERACCESS0_GO)
- ;
-
- return 0;
-}
-
static void __attribute__((unused))
keystone2_eth_gigabit_enable(struct udevice *dev)
{
struct ks2_eth_priv *priv = dev_get_priv(dev);
- u_int16_t data;
-
- if (priv->has_mdio) {
- data = keystone2_mdio_read(priv->mdio_bus, priv->phy_addr,
- MDIO_DEVAD_NONE, 0);
- /* speed selection MSB */
- if (!(data & (1 << 6)))
- return;
- }
/*
* Check if link detected is giga-bit
* If Gigabit mode detected, enable gigbit in MAC
*/
+ if (priv->has_mdio) {
+ if (priv->phydev->speed != 1000)
+ return;
+ }
+
writel(readl(DEVICE_EMACSL_BASE(priv->slave_port - 1) +
CPGMACSL_REG_CTL) |
EMAC_MACCONTROL_GIGFORCE | EMAC_MACCONTROL_GIGABIT_ENABLE,
@@ -484,8 +413,6 @@ static int ks2_eth_start(struct udevice *dev)
hw_config_streaming_switch();
if (priv->has_mdio) {
- keystone2_mdio_reset(priv->mdio_bus);
-
phy_startup(priv->phydev);
if (priv->phydev->link == 0) {
pr_err("phy startup failed\n");
@@ -605,9 +532,9 @@ static int ks2_eth_probe(struct udevice *dev)
{
struct ks2_eth_priv *priv = dev_get_priv(dev);
struct mii_dev *mdio_bus;
- int ret;
priv->dev = dev;
+ priv->emac_open = false;
/* These clock enables has to be moved to common location */
if (cpu_is_k2g())
@@ -626,45 +553,36 @@ static int ks2_eth_probe(struct udevice *dev)
if (cpu_is_k2e() || cpu_is_k2l())
pll_pa_clk_sel();
-
priv->net_rx_buffs.buff_ptr = rx_buffs;
priv->net_rx_buffs.num_buffs = RX_BUFF_NUMS;
priv->net_rx_buffs.buff_len = RX_BUFF_LEN;
if (priv->slave_port == 1) {
+#ifndef CONFIG_SOC_K2G
+ keystone2_net_serdes_setup();
+#endif
/*
* Register MDIO bus for slave 0 only, other slave have
* to re-use the same
*/
- mdio_bus = mdio_alloc();
+ mdio_bus = cpsw_mdio_init("ethernet-mdio",
+ (u32)priv->mdio_base,
+ EMAC_MDIO_CLOCK_FREQ,
+ EMAC_MDIO_BUS_FREQ);
if (!mdio_bus) {
pr_err("MDIO alloc failed\n");
return -ENOMEM;
}
priv->mdio_bus = mdio_bus;
- mdio_bus->read = keystone2_mdio_read;
- mdio_bus->write = keystone2_mdio_write;
- mdio_bus->reset = keystone2_mdio_reset;
- mdio_bus->priv = priv->mdio_base;
- sprintf(mdio_bus->name, "ethernet-mdio");
-
- ret = mdio_register(mdio_bus);
- if (ret) {
- pr_err("MDIO bus register failed\n");
- return ret;
- }
} else {
/* Get the MDIO bus from slave 0 device */
struct ks2_eth_priv *parent_priv;
parent_priv = dev_get_priv(dev->parent);
priv->mdio_bus = parent_priv->mdio_bus;
+ priv->mdio_base = parent_priv->mdio_base;
}
-#ifndef CONFIG_SOC_K2G
- keystone2_net_serdes_setup();
-#endif
-
priv->netcp_pktdma = &netcp_pktdma;
if (priv->has_mdio) {
@@ -680,9 +598,7 @@ int ks2_eth_remove(struct udevice *dev)
{
struct ks2_eth_priv *priv = dev_get_priv(dev);
- free(priv->phydev);
- mdio_unregister(priv->mdio_bus);
- mdio_free(priv->mdio_bus);
+ cpsw_mdio_free(priv->mdio_bus);
return 0;
}
--
2.10.5
More information about the U-Boot
mailing list