[U-Boot] [PATCH 2/3] arm: dts: Add mac node for rk3308 at dtsi level

[David Wu]

Hi Kever,

在 2019/11/27 下午2:23, Kever Yang 写道:
> David,
> 
> 
> On 2019/11/26 上午9:39, David Wu wrote:
>> The rk3308 only support RMII mode, and if it is output clock
>> mode, better to use ref_clk pin with drive strength 12ma.
>>
>> Signed-off-by: David Wu <david.wu at rock-chips.com>
> 
> Did you send this to kernel list at the same time?

I will send it later.

> 
> 
> Thanks,
> 
> - Kever
> 
>> ---
>>   arch/arm/dts/rk3308.dtsi | 22 ++++++++++++++++++++++
>>   1 file changed, 22 insertions(+)
>>
>> diff --git a/arch/arm/dts/rk3308.dtsi b/arch/arm/dts/rk3308.dtsi
>> index 0eeec165d4..a5c0b72ae0 100644
>> --- a/arch/arm/dts/rk3308.dtsi
>> +++ b/arch/arm/dts/rk3308.dtsi
>> @@ -627,6 +627,28 @@
>>           status = "disabled";
>>       };
>> +    mac: ethernet at ff4e0000 {
>> +        compatible = "rockchip,rk3308-mac";
>> +        reg = <0x0 0xff4e0000 0x0 0x10000>;
>> +        rockchip,grf = <&grf>;
>> +        interrupts = <GIC_SPI 64 IRQ_TYPE_LEVEL_HIGH>;
>> +        interrupt-names = "macirq";
>> +        clocks = <&cru SCLK_MAC>, <&cru SCLK_MAC_RX_TX>,
>> +             <&cru SCLK_MAC_RX_TX>, <&cru SCLK_MAC_REF>,
>> +             <&cru SCLK_MAC>, <&cru ACLK_MAC>,
>> +             <&cru PCLK_MAC>, <&cru SCLK_MAC_RMII>;
>> +        clock-names = "stmmaceth", "mac_clk_rx",
>> +                  "mac_clk_tx", "clk_mac_ref",
>> +                  "clk_mac_refout", "aclk_mac",
>> +                  "pclk_mac", "clk_mac_speed";
>> +        phy-mode = "rmii";
>> +        pinctrl-names = "default";
>> +        pinctrl-0 = <&rmii_pins &mac_refclk_12ma>;
>> +        resets = <&cru SRST_MAC_A>;
>> +        reset-names = "stmmaceth";
>> +        status = "disabled";
>> +    };
>> +
>>       cru: clock-controller at ff500000 {
>>           compatible = "rockchip,rk3308-cru";
>>           reg = <0x0 0xff500000 0x0 0x1000>;
> 
> 
> 
>