i.MX8MM-EVK Boot failure

[Fabio Estevam]

Hi Adam,

On Sat, Dec 7, 2019 at 11:42 AM Adam Ford <aford173 at gmail.com> wrote:
>
> I am trying to run the latest master
>
> 4b19b89ca4a866b7baa642533e6dbd67cd832d27
> with the clock patches applied for 8mm, but I am getting a boot
> failure when I follow the instructions in the README, which are also a
> bit wrong.  (the firmware versions don't match, and the ./firmware
> command is missing the trailing '.bin', but it's trivial.)
>
> What comes out of the kit with DEBUG enabled is:
>
> (bunch of stuff deleted)
>
> [PMU Major message = 0x000000fe]
> [PMU Major message = 0x00000007]
> Training PASS
> DDRINFO: ddrphy config done
> DDRINFO:ddrphy calibration done
> DDRINFO: ddrmix config done
> >>SPL: board_init_r()
> using memory lx-lx for malloc()
> spl_init
> Normal Boot
> Trying to boot from MMC1
> common/dlmalloc.c:792: do_check_inuse_chunk: Assertion `inuse(p)' failed.
> resetting ...
>
> The above sequence repeats again and again.  I didn't put all the junk
> into the log because it looked like everything seemed OK until the
> dlmalloc failure at the end.  If someone has any suggestions, I'd like
> to try the 8mm-evk with a modern U-Boot.

Same here on a imx8mq-evk:
https://lists.denx.de/pipermail/u-boot/2019-November/391705.html

I haven't had a chance to look at it deeper, but hopefully we can get
this fixed in time for the 2020.01 release.