[PATCH v2 1/2] drivers: net: fsl_enetc: use write_hwaddr()
Michael Walle
michael at walle.cc
Fri Dec 20 14:16:47 CET 2019
Intead of setting the MAC address in enetc_start() use the proper
write_hwaddr(). U-Boot takes care of the random MAC address, too.
Signed-off-by: Michael Walle <michael at walle.cc>
Signed-off-by: Alex Marginean <alexandru.marginean at nxp.com>
---
changes since v1:
- none, but added a second patch which also handles the ls1028a
drivers/net/fsl_enetc.c | 17 ++++++++---------
1 file changed, 8 insertions(+), 9 deletions(-)
diff --git a/drivers/net/fsl_enetc.c b/drivers/net/fsl_enetc.c
index 02c1ee70d9..52aae61fa9 100644
--- a/drivers/net/fsl_enetc.c
+++ b/drivers/net/fsl_enetc.c
@@ -267,14 +267,19 @@ static int enetc_remove(struct udevice *dev)
return 0;
}
-/* ENETC Port MAC address registers, accepts big-endian format */
-static void enetc_set_primary_mac_addr(struct enetc_priv *priv, const u8 *addr)
+static int enetc_write_hwaddr(struct udevice *dev)
{
+ struct eth_pdata *plat = dev_get_platdata(dev);
+ struct enetc_priv *priv = dev_get_priv(dev);
+ u8 *addr = plat->enetaddr;
+
u16 lower = *(const u16 *)(addr + 4);
u32 upper = *(const u32 *)addr;
enetc_write_port(priv, ENETC_PSIPMAR0, upper);
enetc_write_port(priv, ENETC_PSIPMAR1, lower);
+
+ return 0;
}
/* Configure port parameters (# of rings, frame size, enable port) */
@@ -405,7 +410,6 @@ static void enetc_setup_rx_bdr(struct udevice *dev)
*/
static int enetc_start(struct udevice *dev)
{
- struct eth_pdata *plat = dev_get_platdata(dev);
struct enetc_priv *priv = dev_get_priv(dev);
/* reset and enable the PCI device */
@@ -413,12 +417,6 @@ static int enetc_start(struct udevice *dev)
dm_pci_clrset_config16(dev, PCI_COMMAND, 0,
PCI_COMMAND_MEMORY | PCI_COMMAND_MASTER);
- if (!is_valid_ethaddr(plat->enetaddr)) {
- enetc_dbg(dev, "invalid MAC address, generate random ...\n");
- net_random_ethaddr(plat->enetaddr);
- }
- enetc_set_primary_mac_addr(priv, plat->enetaddr);
-
enetc_enable_si_port(priv);
/* setup Tx/Rx buffer descriptors */
@@ -548,6 +546,7 @@ static const struct eth_ops enetc_ops = {
.send = enetc_send,
.recv = enetc_recv,
.stop = enetc_stop,
+ .write_hwaddr = enetc_write_hwaddr,
};
U_BOOT_DRIVER(eth_enetc) = {
--
2.20.1
More information about the U-Boot
mailing list