[RESEND v7 4/8] Kconfigs: layerscape: use a convenient default value for SYS_MALLOC_F_LEN

[Biwen Li]

The default value of CONFIG_SYS_MALLOC_F_LEN (0x400)
leaves U-Boot with not enough memory to load i2c driver
before relocate, causing it to hang.

Change the default value of CONFIG_SYS_MALLOC_F_LEN
for below SoCs,
- LS1012A
- LS1021A
- LS1043A
- LS1046A

Reviewed-by: Priyanka Jain <priyanka.jain at nxp.com>
Signed-off-by: Biwen Li <biwen.li at nxp.com>
---
Changes in v7:
	- none

Changes in v6:
	- none

Changes in v5:
	- none

Changes in v4:
	- none

Changes in v3:
	- update commit messages

Changes in v2:
	- none

 Kconfig | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/Kconfig b/Kconfig
index 92fc4fc135..3253428bbf 100644
--- a/Kconfig
+++ b/Kconfig
@@ -147,7 +147,9 @@ config SYS_MALLOC_F_LEN
 	default 0x1000 if AM33XX
 	default 0x2800 if SANDBOX
 	default 0x2000 if (ARCH_IMX8 || ARCH_IMX8M || ARCH_MX7 || \
-			   ARCH_MX7ULP || ARCH_MX6 || ARCH_MX5)
+			   ARCH_MX7ULP || ARCH_MX6 || ARCH_MX5 || \
+			   ARCH_LS1012A || ARCH_LS1021A || ARCH_LS1043A || \
+			   ARCH_LS1046A)
 	default 0x400
 	help
 	  Before relocation, memory is very limited on many platforms. Still,
-- 
2.17.1