[U-Boot] [PATCH 1/1] sunxi: board: Add i2c initialization for sun50i

[Jagan Teki]

On Tue, Jan 8, 2019 at 3:47 PM Maxime Ripard <maxime.ripard at bootlin.com> wrote:
>
> On Tue, Jan 08, 2019 at 12:04:30PM +0200, Stefan Mavrodiev wrote:
> > To use TWI0/1/2 the user can select CONFIG_I2C#_ENABLE.
> > However even the controller is enabled, the mux for the pins
> > are not set.
> >
> > This patch follows the existing mux method. Since the pads are
> > different, separate check is added for each i2c.
> >
> > Tested with A64-SOM204 board.
> >
> > Signed-off-by: Stefan Mavrodiev <stefan at olimex.com>
>
>
> Acked-by: Maxime Ripard <maxime.ripard at bootlin.com>

Applied to u-boot-sunxi/master