[U-Boot] [PATCH 26/26] board: mx6sabresd: Remove the enet reset gpio handling

[Abel Vesa]

Rely on the phy-reset-gpios which is set in imx6qdl-sabresd dtsi
and get rid of the enet reset gpio handling from the board file.

Signed-off-by: Abel Vesa <abel.vesa at nxp.com>
---
 board/freescale/mx6sabresd/mx6sabresd.c | 7 -------
 1 file changed, 7 deletions(-)

diff --git a/board/freescale/mx6sabresd/mx6sabresd.c b/board/freescale/mx6sabresd/mx6sabresd.c
index 71b9bfe..c9f2076 100644
--- a/board/freescale/mx6sabresd/mx6sabresd.c
+++ b/board/freescale/mx6sabresd/mx6sabresd.c
@@ -94,13 +94,6 @@ static iomux_v3_cfg_t const enet_pads[] = {
 static void setup_iomux_enet(void)
 {
 	SETUP_IOMUX_PADS(enet_pads);
-
-	/* Reset AR8031 PHY */
-	gpio_request(IMX_GPIO_NR(1, 25), "ENET PHY Reset");
-	gpio_direction_output(IMX_GPIO_NR(1, 25) , 0);
-	mdelay(10);
-	gpio_set_value(IMX_GPIO_NR(1, 25), 1);
-	udelay(100);
 }
 
 static iomux_v3_cfg_t const usdhc2_pads[] = {
-- 
2.7.4