[U-Boot] [PATCH v2 05/22] mmc: fsl_esdhc: Fix DM_REGULATOR ifdefs for SPL builds

[Adam Ford]

On Tue, Jan 29, 2019 at 5:34 AM Abel Vesa <abel.vesa at nxp.com> wrote:
>
> Since the fsl_esdhc will also be used by SPL, make the
> preprocessor switches more generic to allow any kind of build.
>

I have a similar patch pending wtih both DM_GPIO and DM_REGULATOR conversions.

https://patchwork.ozlabs.org/patch/1023230/

adam
> Signed-off-by: Abel Vesa <abel.vesa at nxp.com>
> ---
>  drivers/mmc/fsl_esdhc.c | 8 ++++----
>  1 file changed, 4 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/mmc/fsl_esdhc.c b/drivers/mmc/fsl_esdhc.c
> index b8171ba..47f2a8f 100644
> --- a/drivers/mmc/fsl_esdhc.c
> +++ b/drivers/mmc/fsl_esdhc.c
> @@ -804,7 +804,7 @@ static int esdhc_set_voltage(struct mmc *mmc)
>         case MMC_SIGNAL_VOLTAGE_330:
>                 if (priv->vs18_enable)
>                         return -EIO;
> -#ifdef CONFIG_DM_REGULATOR
> +#if CONFIG_IS_ENABLED(DM_REGULATOR)
>                 if (!IS_ERR_OR_NULL(priv->vqmmc_dev)) {
>                         ret = regulator_set_value(priv->vqmmc_dev, 3300000);
>                         if (ret) {
> @@ -823,7 +823,7 @@ static int esdhc_set_voltage(struct mmc *mmc)
>
>                 return -EAGAIN;
>         case MMC_SIGNAL_VOLTAGE_180:
> -#ifdef CONFIG_DM_REGULATOR
> +#if CONFIG_IS_ENABLED(DM_REGULATOR)
>                 if (!IS_ERR_OR_NULL(priv->vqmmc_dev)) {
>                         ret = regulator_set_value(priv->vqmmc_dev, 1800000);
>                         if (ret) {
> @@ -1442,7 +1442,7 @@ static int fsl_esdhc_probe(struct udevice *dev)
>         int node = dev_of_offset(dev);
>         struct esdhc_soc_data *data =
>                 (struct esdhc_soc_data *)dev_get_driver_data(dev);
> -#ifdef CONFIG_DM_REGULATOR
> +#if CONFIG_IS_ENABLED(DM_REGULATOR)
>         struct udevice *vqmmc_dev;
>  #endif
>         fdt_addr_t addr;
> @@ -1500,7 +1500,7 @@ static int fsl_esdhc_probe(struct udevice *dev)
>
>         priv->vs18_enable = 0;
>
> -#ifdef CONFIG_DM_REGULATOR
> +#if CONFIG_IS_ENABLED(DM_REGULATOR)
>         /*
>          * If emmc I/O has a fixed voltage at 1.8V, this must be provided,
>          * otherwise, emmc will work abnormally.
> --
> 2.7.4
>
> _______________________________________________
> U-Boot mailing list
> U-Boot at lists.denx.de
> https://lists.denx.de/listinfo/u-boot