[U-Boot] [PATCH 33/52] ddr: imx8m: Fix the ddr init hang on imx8mq

[peng.fan at nxp.com]

From: Jacky Bai <ping.bai at nxp.com>

On, i.MX8MQ, the PLL config must be done when ddrmix
isolation is released. So move the dram pll init after
iso config done. For other i.MX8M SOC, either init pll
before or after isolation is ok.

Signed-off-by: Jacky Bai <ping.bai at nxp.com>
Signed-off-by: Peng Fan <peng.fan at nxp.com>
---
 drivers/ddr/imx/imx8m/ddr_init.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/ddr/imx/imx8m/ddr_init.c b/drivers/ddr/imx/imx8m/ddr_init.c
index 12967583ea..d6e915c9b9 100644
--- a/drivers/ddr/imx/imx8m/ddr_init.c
+++ b/drivers/ddr/imx/imx8m/ddr_init.c
@@ -41,14 +41,14 @@ void ddr_init(struct dram_timing_info *dram_timing)
 	clock_set_target_val(DRAM_APB_CLK_ROOT, CLK_ROOT_ON | CLK_ROOT_SOURCE_SEL(4) |
 			     CLK_ROOT_PRE_DIV(CLK_ROOT_PRE_DIV4));
 
-	initial_drate = dram_timing->fsp_msg[0].drate;
-	/* default to the frequency point 0 clock */
-	ddrphy_init_set_dfi_clk(initial_drate);
-
 	/* disable iso */
 	reg32_write(0x303A00EC, 0x0000ffff); /* PGC_CPU_MAPPING */
 	reg32setbit(0x303A00F8, 5); /* PU_PGC_SW_PUP_REQ */
 
+	initial_drate = dram_timing->fsp_msg[0].drate;
+	/* default to the frequency point 0 clock */
+	ddrphy_init_set_dfi_clk(initial_drate);
+
 	/* D-aasert the presetn */
 	reg32_write(SRC_DDRC_RCR_ADDR, 0x8F000006);
 
-- 
2.16.4