[U-Boot] [PATCH 3/3] arm: mvebu: clearfog: update eMMC documentation

[Baruch Siach]

SPL now automatically selects the correct U-Boot image offset for both
eMMC and SD card. No need to tweak
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR anymore.

Signed-off-by: Baruch Siach <baruch at tkos.co.il>
---
 board/solidrun/clearfog/README | 6 ------
 1 file changed, 6 deletions(-)

diff --git a/board/solidrun/clearfog/README b/board/solidrun/clearfog/README
index 6171ce66f4f8..9375be84957a 100644
--- a/board/solidrun/clearfog/README
+++ b/board/solidrun/clearfog/README
@@ -20,12 +20,6 @@ of "/dev/sdX" here!
 Install U-Boot on eMMC:
 -----------------------
 
-The ROM loads the bootloader from eMMC first boot partition at offset 0. This
-is unlike load from SD card that is at offset 512. As a result, the offset of
-the main U-Boot image on the eMMC boot partition changes. Set
-CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR to 0x140 for SPL to load U-Boot from
-the correct location.
-
 To make SPL load the main U-Boot image from the eMMC boot partition enable
 eMMC boot acknowledgement and boot partition with the following U-Boot
 command:
-- 
2.20.1