[U-Boot] [PATCH v5 1/4] mmc: mmc_spi: Use SPI_XFER_BEGIN and SPI_XFER_END flags

[Jagan Teki]

On Wed, Jul 17, 2019 at 10:45 AM Jagan Teki <jagan at amarulasolutions.com> wrote:
>
> On Wed, Jul 17, 2019 at 9:40 AM Jagan Teki <jagan at amarulasolutions.com> wrote:
> >
> > Hi Peng,
> >
> > On Wed, Jul 17, 2019 at 9:34 AM Jagan Teki <jagan at amarulasolutions.com> wrote:
> > >
> > > On Wed, Jul 17, 2019 at 9:20 AM Anup Patel <Anup.Patel at wdc.com> wrote:
> > > >
> > > > Most DM based SPI host controller drivers use SPI_XFER_BEGIN and
> > > > SPI_XFER_END flags to enable/disable slave chip select.
> > > >
> > > > This patch extends MMC SPI driver to pass SPI_XFER_BEGIN flag when
> > > > MMC command is send at start and pass SPI_XFER_END flag using a
> > > > dummy transfer (of bitlen = 0) at the end of MMC command.
> > > >
> > > > Suggested-by: Jagan Teki <jagan at amarulasolutions.com>
> > > > Signed-off-by: Anup Patel <anup.patel at wdc.com>
> > >
> > > Reviewed-by: Jagan Teki <jagan at amarulasolutions.com>
> >
> > Would like to pick this via spi tree, let me know if it fine for you?
>
> Look like it has dependency on your tree,  please take this from mmc.

Sorry for the noise, the dependent patch is already in master. So

Applied to u-boot-spi/master