[U-Boot] [PATCH v4 2/2] regulator: bd718x7: support ROHM BD71837 and BD71847 PMICs

[sbabic at denx.de]

> BD71837 and BD71847 is PMIC intended for powering single-core,
> dual-core, and quad-core SoC’s such as NXP-i.MX 8M. BD71847
> is used for example on NXP imx8mm EVK.
> Add regulator driver for ROHM BD71837 and BD71847 PMICs.
> BD71837 contains 8 bucks and 7 LDOS. BD71847 is reduced
> version containing 6 bucks and 6 LDOs. Voltages for DVS
> bucks (1-4 on BD71837, 1 and 2 on BD71847) can be adjusted
> when regulators are enabled. For other bucks and LDOs we may
> have over- or undershooting if voltage is adjusted when
> regulator is enabled. Thus this is prevented by default.
> BD718x7 has a quirk which may leave power output disabled
> after reset if enable/disable state was controlled by SW.
> Thus the SW control is only allowed for BD71837  bucks
> 3 and 4 by default. The impact of this limitation must be
> evaluated board-by board and restrictions may need to be
> modified. (Linux driver get's these limitations from DT and we
> may want to implement same on u-Boot driver).
> Signed-off-by: Matti Vaittinen <matti.vaittinen at fi.rohmeurope.com>
> Reviewed-by: Simon Glass <sjg at chromium.org>

Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================