[U-Boot] [PATCH 1/3] spl: imx6: Let spl_boot_device return USDHC1 or USDHC2

[sbabic at denx.de]

> Currently, when the spl_boot_device checks the boot device, it
> will only return MMC1 when it's either sd or eMMC regardless
> of whether or not it's MMC1 or MMC2.  This is a problem when
> booting from MMC2 if MMC isn't being manually configured like in
> the DM_SPL case with SPL_OF_CONTROL.
> This patch will check the register and return either MMC1 or MMC2.
> Signed-off-by: Adam Ford <aford173 at gmail.com>
> diff --git a/arch/arm/mach-imx/spl.c b/arch/arm/mach-imx/spl.c
> index 9f1e0f6a72..1f230aca33 100644
> --- a/arch/arm/mach-imx/spl.c
> +++ b/arch/arm/mach-imx/spl.c
> @@ -24,6 +24,7 @@ u32 spl_boot_device(void)
>  {
>  	unsigned int bmode = readl(&src_base->sbmr2);
>  	u32 reg = imx6_src_get_boot_mode();
> +	u32 mmc_index = ((reg >> 11) & 0x03);
>  
>  	/*
>  	 * Check for BMODE if serial downloader is enabled
> @@ -84,11 +85,12 @@ u32 spl_boot_device(void)
>  	/* SD/eSD: 8.5.3, Table 8-15  */
>  	case IMX6_BMODE_SD:
>  	case IMX6_BMODE_ESD:
> -		return BOOT_DEVICE_MMC1;
> -	/* MMC/eMMC: 8.5.3 */
>  	case IMX6_BMODE_MMC:
>  	case IMX6_BMODE_EMMC:
> -		return BOOT_DEVICE_MMC1;
> +		if (mmc_index == 1)
> +			return BOOT_DEVICE_MMC2;
> +		else
> +			return BOOT_DEVICE_MMC1;
>  	/* NAND Flash: 8.5.2, Table 8-10 */
>  	case IMX6_BMODE_NAND_MIN ... IMX6_BMODE_NAND_MAX:
>  		return BOOT_DEVICE_NAND;

Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================