[U-Boot] [PATCH] regulator: fixed: Modify enable-active-high behavior

[Patrice Chotard]

Regulator should not be enabled at probe time if regulator-boot-on
property is not in the dt node.

"enable-active-high" property is only used to indicate the GPIO
polarity.

See kernel documentation :
 - Documentation/devicetree/bindings/regulator/fixed-regulator.yaml
 - Documentation/devicetree/bindings/regulator/gpio-regulator.yaml

Signed-off-by: Christophe Kerello <christophe.kerello at st.com>
Signed-off-by: Patrice Chotard <patrice.chotard at st.com>
---

 drivers/power/regulator/regulator_common.c | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/drivers/power/regulator/regulator_common.c b/drivers/power/regulator/regulator_common.c
index 3dabbe2a85..2e8a083c75 100644
--- a/drivers/power/regulator/regulator_common.c
+++ b/drivers/power/regulator/regulator_common.c
@@ -15,7 +15,9 @@ int regulator_common_ofdata_to_platdata(struct udevice *dev,
 	int flags = GPIOD_IS_OUT;
 	int ret;
 
-	if (dev_read_bool(dev, "enable-active-high"))
+	if (!dev_read_bool(dev, "enable-active-high"))
+		flags |= GPIOD_ACTIVE_LOW;
+	if (uc_pdata->boot_on)
 		flags |= GPIOD_IS_OUT_ACTIVE;
 
 	/* Get optional enable GPIO desc */
-- 
2.17.1