[U-Boot] [PATCH] usb: ehci-omap: Add Support DM_USB and OF_CONTROL

[Marek Vasut]

On 7/29/19 2:16 PM, Adam Ford wrote:
> On Sun, Jun 30, 2019 at 5:21 PM Adam Ford <aford173 at gmail.com> wrote:
>>
>> The omap3.dtsi file shows the usbhshost node with two sub-nodes
>> for ohci and ehci.  This patch file creates the usbhshost, and
>> pulls the portX-mode information.  It then locates the EHCI
>> sub-node, and initializes the EHCI controller with the info
>> pulled from the usbhshost node.
>>
>> There is still more to do since there isn't an actual link
>> between the 'phys' reference and the corresponding phy driver,
>> and there is no nop-xceiv driver yet.
>>
>> In the meantime, the older style reference to
>> CONFIG_OMAP_EHCI_PHYx_RESET_GPIO is still needed to pull
>> the phy out of reset until the phy driver is completed and the
>> phandle reference is made.
>>
>> Signed-off-by: Adam Ford <aford173 at gmail.com>
>>
> 
> Marek,
> 
> Some subsequent patches that were depending on this have been applied
> already, but they cannot be really useful until this patch is applied.
> Is there any chance it can be applied?  It will give some of the OMAP3
> boards the USB EHCI functionality which has been lost for a little
> while.

Sure, I am kinda busy and don't have enough free time to cope with this.
Moreover, u-boot-usb/master fails to build:
https://travis-ci.org/marex/u-boot-usb/builds/563567738

Can you take a look whether it's this patchset that causes it ?