[U-Boot] [PATCH v4 0/5] net: ethernet: ti: Introduce am654 gigabit eth switch subsystem driver

[Keerthy]

On 07/06/19 7:02 AM, Tom Rini wrote:
> On Thu, Jun 06, 2019 at 05:08:16PM +0530, Keerthy wrote:
>>
>>
>> On 02/05/19 11:14 AM, Keerthy wrote:
>>>
>>>
>>> On 30/04/19 11:57 AM, Keerthy wrote:
>>>>
>>>>
>>>> On 30/04/19 11:54 AM, Keerthy wrote:
>>>>> Add new driver for the TI AM65x SoC Gigabit Ethernet Switch subsystem
>>>>> (CPSW
>>>>> NUSS). It has two ports and provides Ethernet packet communication for
>>>>> the
>>>>> device and can be configured as an Ethernet switch. CPSW NUSS
>>>>> features: the
>>>>> Reduced Gigabit Media Independent Interface (RGMII), Reduced Media
>>>>> Independent Interface (RMII), and the Management Data Input/Output
>>>>> (MDIO)
>>>>> interface for physical layer device (PHY) management. The TI AM65x SoC
>>>>> has
>>>>> integrated two-port Gigabit Ethernet Switch subsystem into device MCU
>>>>> domain named MCU_CPSW0. One Ethernet port (port 1) with selectable RGMII
>>>>> and RMII interfaces and an internal Communications Port Programming
>>>>> Interface (CPPI) port (Host port 0).
>>>>>
>>>>> Host Port 0 CPPI Packet Streaming Interface interface supports 8 TX
>>>>> channels and on RX channels operating by TI am654 NAVSS Unified DMA
>>>>> Peripheral Root Complex (UDMA-P) controller.
>>>>>
>>>>> Tested for tftp and booting to kernel on am654-evm.
>>>>
>>>> https://patchwork.ozlabs.org/patch/1090618/
>>>>
>>>> Needs to be applied before trying the cpsw.
>>>
>>> Tom,
>>>
>>> Thanks for pulling this series and as pointed above please pull the patch
>>> [1] which will avoid udma accessing RT registers before channel config is
>>> done.
>>
>> Tom,
>>
>> I do not see this series in latest u-boot. Was this dropped for some reason?
> 
> Just came in late in the cycle, I'll pick it up next release, thanks!

Please pick v5.

Regards,
Keerthy
>