[U-Boot] [PATCH 2/3] configs: icorem6: Enable nandbcb command

Shyam Saini shyam.saini at amarulasolutions.com
Fri Jun 14 07:35:34 UTC 2019


This also enables mtd configs which are required by nandbcb command.

This command would be used to configure boot control block(BCB) while
writing spl image on nand device.

Signed-off-by: Shyam Saini <shyam.saini at amarulasolutions.com>
---
 configs/imx6qdl_icore_mmc_defconfig | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/configs/imx6qdl_icore_mmc_defconfig b/configs/imx6qdl_icore_mmc_defconfig
index b65979967a..620d49f954 100644
--- a/configs/imx6qdl_icore_mmc_defconfig
+++ b/configs/imx6qdl_icore_mmc_defconfig
@@ -15,6 +15,7 @@ CONFIG_DEBUG_UART_BASE=0x021f0000
 CONFIG_DEBUG_UART_CLOCK=24000000
 CONFIG_SPL_LIBDISK_SUPPORT=y
 # CONFIG_CMD_BMODE is not set
+CONFIG_CMD_NANDBCB=y
 CONFIG_DEBUG_UART=y
 CONFIG_FIT=y
 CONFIG_FIT_SIGNATURE=y
@@ -58,6 +59,9 @@ CONFIG_SYS_I2C_MXC=y
 CONFIG_FSL_ESDHC=y
 CONFIG_NAND=y
 CONFIG_NAND_MXS=y
+CONFIG_CMD_MTDPARTS=y
+CONFIG_MTDIDS_DEFAULT="nand0=gpmi-nand"
+CONFIG_MTDPARTS_DEFAULT="mtdparts=gpmi-nand:2m(spl),2m(uboot),1m(env),8m(kernel),1m(dtb),-(rootfs)"
 CONFIG_PHYLIB=y
 CONFIG_PHY_SMSC=y
 CONFIG_FEC_MXC=y
-- 
2.11.0



More information about the U-Boot mailing list