[U-Boot] [RESEND][PATCH v1 3/4] board: stm32mp1: Add tx_fifo_sz_array support

[Marek Vasut]

On 3/14/19 11:51 AM, Patrice Chotard wrote:
> Allows to use an array of tx-fifo-size defined in device tree
> as following:
>    g-tx-fifo-size = <128 128 64 64 64 64 32 32>;
> 
> Signed-off-by: Patrice Chotard <patrice.chotard at st.com>
> ---
> 
>  board/st/stm32mp1/stm32mp1.c | 11 +++++++++--
>  1 file changed, 9 insertions(+), 2 deletions(-)
> 
> diff --git a/board/st/stm32mp1/stm32mp1.c b/board/st/stm32mp1/stm32mp1.c
> index 54feca0ecff5..81c080ff3199 100644
> --- a/board/st/stm32mp1/stm32mp1.c
> +++ b/board/st/stm32mp1/stm32mp1.c
> @@ -42,6 +42,7 @@ int board_usb_init(int index, enum usb_init_type init)
>  	int node;
>  	int phy_provider;
>  	int ret;
> +	int count;
>  
>  	/* find the usb otg node */
>  	node = fdt_node_offset_by_compatible(blob, -1, "snps,dwc2");
> @@ -138,8 +139,14 @@ int board_usb_init(int index, enum usb_init_type init)
>  						     "g-rx-fifo-size", 0);
>  	stm32mp_otg_data.np_tx_fifo_sz = fdtdec_get_int(blob, node,
>  							"g-np-tx-fifo-size", 0);
> -	stm32mp_otg_data.tx_fifo_sz = fdtdec_get_int(blob, node,
> -						     "g-tx-fifo-size", 0);
> +
> +	count = fdtdec_get_int_array_count(blob, node, "g-tx-fifo-size",
> +			&stm32mp_otg_data.tx_fifo_sz_array[DWC2_SIZE_OFFS],
> +			ARRAY_SIZE(stm32mp_otg_data.tx_fifo_sz_array));
> +
> +	if (count != -FDT_ERR_NOTFOUND)
> +		stm32mp_otg_data.tx_fifo_sz_array[DWC2_SIZE_NB_OFFS] = count;

This should be in the driver , not board code.

>  	/* Enable voltage level detector */
>  	if (!(fdtdec_parse_phandle_with_args(blob, node, "usb33d-supply",
>  					     NULL, 0, 0, &args))) {
> 


-- 
Best regards,
Marek Vasut