[U-Boot] [PATCH 02/11] arm: at91: spl_at91.c: Call spl_early_init() if OF_CONTROL is enabled

[Stefan Roese]

This patch adds a call to spl_early_init() to board_init_f() which is
needed when CONFIG_SPL_OF_CONTROL is configured. This is necessary for
the early SPL setup including the DTB setup for later usage.

Please note that this call might also be needed for non SPL_OF_CONTROL
board, like the smartweb target. But smartweb fails to build with this
call because its binary grows too big. So I disabled it for these kind
of targets for now.

Signed-off-by: Stefan Roese <sr at denx.de>
Cc: Heiko Schocher <hs at denx.de>
Cc: Andreas Bießmann <andreas at biessmann.org>
Cc: Eugen Hristev <eugen.hristev at microchip.com>
---
 arch/arm/mach-at91/spl_at91.c | 10 ++++++++++
 1 file changed, 10 insertions(+)

diff --git a/arch/arm/mach-at91/spl_at91.c b/arch/arm/mach-at91/spl_at91.c
index 23ebaa99b1..1065f090e0 100644
--- a/arch/arm/mach-at91/spl_at91.c
+++ b/arch/arm/mach-at91/spl_at91.c
@@ -75,6 +75,16 @@ void __weak spl_board_init(void)
 
 void board_init_f(ulong dummy)
 {
+#if CONFIG_IS_ENABLED(OF_CONTROL)
+	int ret;
+
+	ret = spl_early_init();
+	if (ret) {
+		debug("spl_early_init() failed: %d\n", ret);
+		hang();
+	}
+#endif
+
 	lowlevel_clock_init();
 #if !defined(CONFIG_WDT_AT91)
 	at91_disable_wdt();
-- 
2.21.0