[U-Boot] [PATCH v3 1/2] sunxi: Enable EMAC on the Cubietruck Plus

Chen-Yu Tsai wens at kernel.org
Fri May 3 02:27:40 UTC 2019


From: Chen-Yu Tsai <wens at csie.org>

The Cubietruck Plus has an RTL8211E PHY connected to the EMAC using
RGMII. The PHY is powered by DLDO4 @ 3.3V, while the I/O pins are
powered by DLDO3 @ 2.5V.

This patch enables the EMAC and Realtek PHY drivers in the defconfig.
The device tree file already has the EMAC enabled.

Signed-off-by: Chen-Yu Tsai <wens at csie.org>
---

Changes in v3: None
Changes in v2: None

 configs/Cubietruck_plus_defconfig | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/configs/Cubietruck_plus_defconfig b/configs/Cubietruck_plus_defconfig
index 869bffcfca0c..044af12779c6 100644
--- a/configs/Cubietruck_plus_defconfig
+++ b/configs/Cubietruck_plus_defconfig
@@ -20,6 +20,8 @@ CONFIG_CONSOLE_MUX=y
 # CONFIG_SPL_DOS_PARTITION is not set
 # CONFIG_SPL_EFI_PARTITION is not set
 CONFIG_DEFAULT_DEVICE_TREE="sun8i-a83t-cubietruck-plus"
+CONFIG_PHY_REALTEK=y
+CONFIG_SUN8I_EMAC=y
 CONFIG_AXP_DLDO3_VOLT=2500
 CONFIG_AXP_DLDO4_VOLT=3300
 CONFIG_AXP_FLDO1_VOLT=1200
-- 
2.20.1



More information about the U-Boot mailing list