[U-Boot] [PATCH 1/3] board: atmel: sama5d2_icp: add periph reset in SPL hw init

[Eugen.Hristev at microchip.com]

On 08.05.2019 15:58, Eugen Hristev - M18282 wrote:
> From: Eugen Hristev <eugen.hristev at microchip.com>
> 
> Some periphs on the board need to be reset by holding their reset GPIO down
> for a specific time period.
> On a warm reset, the periphs are not being reset by any reset pin and may be
> in a wrong state.
> Reset them in the SPL to make sure we are booting into the correct state
> machine of the specific board periphs (KSZ eth switch, USB hub, HSIC eth,
> Ethercat)
> 
> Signed-off-by: Eugen Hristev <eugen.hristev at microchip.com>
> ---

Applied all 3 patches to u-boot-atmel/master