[U-Boot] [PATCH 2/5] pci: imx: Factor out hard-coded register base addresses
Marek Vasut
marex at denx.de
Fri May 17 18:26:06 UTC 2019
Pull out hard-coded register base addresses into driver private
structure in preparation for DM conversion. No functional change.
Signed-off-by: Marek Vasut <marex at denx.de>
Cc: Bin Meng <bmeng.cn at gmail.com>
Cc: Fabio Estevam <fabio.estevam at nxp.com>
Cc: Stefano Babic <sbabic at denx.de>
---
drivers/pci/pcie_imx.c | 75 +++++++++++++++++++++++++-----------------
1 file changed, 44 insertions(+), 31 deletions(-)
diff --git a/drivers/pci/pcie_imx.c b/drivers/pci/pcie_imx.c
index fcc4ab7139..173636f48e 100644
--- a/drivers/pci/pcie_imx.c
+++ b/drivers/pci/pcie_imx.c
@@ -92,6 +92,18 @@
#define PCIE_ATU_FUNC(x) (((x) & 0x7) << 16)
#define PCIE_ATU_UPPER_TARGET 0x91C
+struct imx_pcie_priv {
+ void __iomem *dbi_base;
+ void __iomem *cfg_base;
+};
+
+static struct imx_pcie_priv imx_pcie_priv = {
+ .dbi_base = (void __iomem *)MX6_DBI_ADDR,
+ .cfg_base = (void __iomem *)MX6_ROOT_ADDR,
+};
+
+static struct imx_pcie_priv *priv = &imx_pcie_priv;
+
/*
* PHY access functions
*/
@@ -231,7 +243,7 @@ static int imx6_pcie_link_up(void)
int rx_valid, temp;
/* link is debug bit 36, debug register 1 starts at bit 32 */
- rc = readl(MX6_DBI_ADDR + PCIE_PHY_DEBUG_R1);
+ rc = readl(priv->dbi_base + PCIE_PHY_DEBUG_R1);
if ((rc & PCIE_PHY_DEBUG_R1_LINK_UP) &&
!(rc & PCIE_PHY_DEBUG_R1_LINK_IN_TRAINING))
return -EAGAIN;
@@ -243,8 +255,8 @@ static int imx6_pcie_link_up(void)
* && (PHY/rx_valid==0) then pulse PHY/rx_reset. Transition
* to gen2 is stuck
*/
- pcie_phy_read((void *)MX6_DBI_ADDR, PCIE_PHY_RX_ASIC_OUT, &rx_valid);
- ltssm = readl(MX6_DBI_ADDR + PCIE_PHY_DEBUG_R0) & 0x3F;
+ pcie_phy_read(priv->dbi_base, PCIE_PHY_RX_ASIC_OUT, &rx_valid);
+ ltssm = readl(priv->dbi_base + PCIE_PHY_DEBUG_R0) & 0x3F;
if (rx_valid & 0x01)
return 0;
@@ -254,15 +266,15 @@ static int imx6_pcie_link_up(void)
printf("transition to gen2 is stuck, reset PHY!\n");
- pcie_phy_read((void *)MX6_DBI_ADDR, PHY_RX_OVRD_IN_LO, &temp);
+ pcie_phy_read(priv->dbi_base, PHY_RX_OVRD_IN_LO, &temp);
temp |= (PHY_RX_OVRD_IN_LO_RX_DATA_EN | PHY_RX_OVRD_IN_LO_RX_PLL_EN);
- pcie_phy_write((void *)MX6_DBI_ADDR, PHY_RX_OVRD_IN_LO, temp);
+ pcie_phy_write(priv->dbi_base, PHY_RX_OVRD_IN_LO, temp);
udelay(3000);
- pcie_phy_read((void *)MX6_DBI_ADDR, PHY_RX_OVRD_IN_LO, &temp);
+ pcie_phy_read(priv->dbi_base, PHY_RX_OVRD_IN_LO, &temp);
temp &= ~(PHY_RX_OVRD_IN_LO_RX_DATA_EN | PHY_RX_OVRD_IN_LO_RX_PLL_EN);
- pcie_phy_write((void *)MX6_DBI_ADDR, PHY_RX_OVRD_IN_LO, temp);
+ pcie_phy_write(priv->dbi_base, PHY_RX_OVRD_IN_LO, temp);
return 0;
}
@@ -285,24 +297,25 @@ static int imx_pcie_regions_setup(void)
*/
/* CMD reg:I/O space, MEM space, and Bus Master Enable */
- setbits_le32(MX6_DBI_ADDR | PCI_COMMAND,
+ setbits_le32(priv->dbi_base + PCI_COMMAND,
PCI_COMMAND_IO | PCI_COMMAND_MEMORY | PCI_COMMAND_MASTER);
/* Set the CLASS_REV of RC CFG header to PCI_CLASS_BRIDGE_PCI */
- setbits_le32(MX6_DBI_ADDR + PCI_CLASS_REVISION,
+ setbits_le32(priv->dbi_base + PCI_CLASS_REVISION,
PCI_CLASS_BRIDGE_PCI << 16);
/* Region #0 is used for Outbound CFG space access. */
- writel(0, MX6_DBI_ADDR + PCIE_ATU_VIEWPORT);
+ writel(0, priv->dbi_base + PCIE_ATU_VIEWPORT);
- writel(MX6_ROOT_ADDR, MX6_DBI_ADDR + PCIE_ATU_LOWER_BASE);
- writel(0, MX6_DBI_ADDR + PCIE_ATU_UPPER_BASE);
- writel(MX6_ROOT_ADDR + MX6_ROOT_SIZE, MX6_DBI_ADDR + PCIE_ATU_LIMIT);
+ writel((u32)priv->cfg_base, priv->dbi_base + PCIE_ATU_LOWER_BASE);
+ writel(0, priv->dbi_base + PCIE_ATU_UPPER_BASE);
+ writel((u32)priv->cfg_base + MX6_ROOT_SIZE,
+ priv->dbi_base + PCIE_ATU_LIMIT);
- writel(0, MX6_DBI_ADDR + PCIE_ATU_LOWER_TARGET);
- writel(0, MX6_DBI_ADDR + PCIE_ATU_UPPER_TARGET);
- writel(PCIE_ATU_TYPE_CFG0, MX6_DBI_ADDR + PCIE_ATU_CR1);
- writel(PCIE_ATU_ENABLE, MX6_DBI_ADDR + PCIE_ATU_CR2);
+ writel(0, priv->dbi_base + PCIE_ATU_LOWER_TARGET);
+ writel(0, priv->dbi_base + PCIE_ATU_UPPER_TARGET);
+ writel(PCIE_ATU_TYPE_CFG0, priv->dbi_base + PCIE_ATU_CR1);
+ writel(PCIE_ATU_ENABLE, priv->dbi_base + PCIE_ATU_CR2);
return 0;
}
@@ -315,18 +328,18 @@ static uint32_t get_bus_address(pci_dev_t d, int where)
uint32_t va_address;
/* Reconfigure Region #0 */
- writel(0, MX6_DBI_ADDR + PCIE_ATU_VIEWPORT);
+ writel(0, priv->dbi_base + PCIE_ATU_VIEWPORT);
if (PCI_BUS(d) < 2)
- writel(PCIE_ATU_TYPE_CFG0, MX6_DBI_ADDR + PCIE_ATU_CR1);
+ writel(PCIE_ATU_TYPE_CFG0, priv->dbi_base + PCIE_ATU_CR1);
else
- writel(PCIE_ATU_TYPE_CFG1, MX6_DBI_ADDR + PCIE_ATU_CR1);
+ writel(PCIE_ATU_TYPE_CFG1, priv->dbi_base + PCIE_ATU_CR1);
if (PCI_BUS(d) == 0) {
- va_address = MX6_DBI_ADDR;
+ va_address = (u32)priv->dbi_base;
} else {
- writel(d << 8, MX6_DBI_ADDR + PCIE_ATU_LOWER_TARGET);
- va_address = MX6_IO_ADDR + SZ_16M - SZ_1M;
+ writel(d << 8, priv->dbi_base + PCIE_ATU_LOWER_TARGET);
+ va_address = (u32)priv->cfg_base;
}
va_address += (where & ~0x3);
@@ -465,12 +478,12 @@ static int imx6_pcie_assert_core_reset(bool prepare_for_boot)
gpr12 = readl(&iomuxc_regs->gpr[12]);
if ((gpr1 & IOMUXC_GPR1_PCIE_REF_CLK_EN) &&
(gpr12 & IOMUXC_GPR12_PCIE_CTL_2)) {
- val = readl(MX6_DBI_ADDR + PCIE_PL_PFLR);
+ val = readl(priv->dbi_base + PCIE_PL_PFLR);
val &= ~PCIE_PL_PFLR_LINK_STATE_MASK;
val |= PCIE_PL_PFLR_FORCE_LINK;
imx_pcie_fix_dabt_handler(true);
- writel(val, MX6_DBI_ADDR + PCIE_PL_PFLR);
+ writel(val, priv->dbi_base + PCIE_PL_PFLR);
imx_pcie_fix_dabt_handler(false);
gpr12 &= ~IOMUXC_GPR12_PCIE_CTL_2;
@@ -621,9 +634,9 @@ static int imx_pcie_link_up(void)
* Force the PCIe RC subordinate to 0xff, otherwise no downstream
* devices will be detected if the enumeration is applied strictly.
*/
- tmp = readl(MX6_DBI_ADDR + 0x18);
+ tmp = readl(priv->dbi_base + 0x18);
tmp |= (0xff << 16);
- writel(tmp, MX6_DBI_ADDR + 0x18);
+ writel(tmp, priv->dbi_base + 0x18);
/*
* FIXME: Force the PCIe RC to Gen1 operation
@@ -631,10 +644,10 @@ static int imx_pcie_link_up(void)
* up, otherwise no downstream devices are detected. After the
* link is up, a managed Gen1->Gen2 transition can be initiated.
*/
- tmp = readl(MX6_DBI_ADDR + 0x7c);
+ tmp = readl(priv->dbi_base + 0x7c);
tmp &= ~0xf;
tmp |= 0x1;
- writel(tmp, MX6_DBI_ADDR + 0x7c);
+ writel(tmp, priv->dbi_base + 0x7c);
/* LTSSM enable, starting link. */
setbits_le32(&iomuxc_regs->gpr[12], IOMUXC_GPR12_APPS_LTSSM_ENABLE);
@@ -647,8 +660,8 @@ static int imx_pcie_link_up(void)
puts("PCI: pcie phy link never came up\n");
#endif
debug("DEBUG_R0: 0x%08x, DEBUG_R1: 0x%08x\n",
- readl(MX6_DBI_ADDR + PCIE_PHY_DEBUG_R0),
- readl(MX6_DBI_ADDR + PCIE_PHY_DEBUG_R1));
+ readl(priv->dbi_base + PCIE_PHY_DEBUG_R0),
+ readl(priv->dbi_base + PCIE_PHY_DEBUG_R1));
return -EINVAL;
}
}
--
2.20.1
More information about the U-Boot
mailing list