[U-Boot] imx8mq-evk boot regression

[Patrick Wildt]

On Mon, Nov 25, 2019 at 01:18:26PM -0300, Fabio Estevam wrote:
> Hi,
> 
> Just tried to boot imx8mq-evk using latest U-Boot master and this is what I get:
> 
> U-Boot SPL 2020.01-rc3-00070-g9a0cbae22a (Nov 25 2019 - 13:08:24 -0300)
> PMIC:  PFUZE100 ID=0x10
> DDRINFO: start DRAM init
> DDRINFO:ddrphy calibration done
> DDRINFO: ddrmix config done
> Normal Boot
> Trying to boot from MMC2
> 
> (It hangs here)
> 
> I haven't tried to debug this yet, but just wanted to let you know in
> case this is a known issue.
> 
> Any ideas?
> 
> Thanks,

Hi,

just tried it here as well, and for me it gets to the U-Boot command-
line, but then there it cannot access the SD card anymore.  At least
that's further than what you have.

U-Boot SPL 2020.01-rc3-00082-g4b19b89ca4-dirty (Nov 26 2019 - 10:05:34 +0100)
PMIC:  PFUZE100 ID=0x10
DDRINFO: start DRAM init
DDRINFO:ddrphy calibration done
DDRINFO: ddrmix config done
Normal Boot
Trying to boot from MMC2


U-Boot 2020.01-rc3-00082-g4b19b89ca4-dirty (Nov 26 2019 - 10:05:34 +0100)

CPU:   Freescale i.MX8MQ rev2.0 at 1000 MHz
Reset cause: POR
Model: NXP i.MX8MQ EVK
DRAM:  3 GiB
MMC:   FSL_SDHC: 0, FSL_SDHC: 1
Loading Environment from MMC... unable to select a mode
*** Warning - No block device, using default environment

In:    serial
Out:   serial
Err:   serial
Net:   
Warning: ethernet at 30be0000 using MAC address from ROM
eth0: ethernet at 30be0000
Hit any key to stop autoboot:  0 
u-boot=> mmc dev 0
switch to partitions #0, OK
mmc0(part 0) is current device
u-boot=> mmc dev 1
unable to select a mode

Thanks,
Patrick