[U-Boot] [PATCH V1 5/6] net: fec_mxc: support i.MX8M with CLK_CCF

Schrempf Frieder frieder.schrempf at kontron.de
Thu Oct 24 07:53:20 UTC 2019


On 24.10.19 03:09, Peng Fan wrote:
>> Subject: Re: [U-Boot] [PATCH V1 5/6] net: fec_mxc: support i.MX8M with
>> CLK_CCF
>>
>> On 22.10.19 05:30, Peng Fan wrote:
>>> Add more clks for fec_mxc according to Linux Kernel 5.4.0-rc1
>>> drivers/net/ethernet/freescale/fec_main.c.
>>>
>>> Since i.MX8MQ not support CLK_CCF, so add a check to restrict the code
>>> only effect when CONFIG_IMX8M and CONFIG_CLK_CCF both defined.
>>>
>>> Signed-off-by: Peng Fan <peng.fan at nxp.com>
>>> ---
>>>    drivers/net/fec_mxc.c | 74
>> ++++++++++++++++++++++++++++++++++++++++-----------
>>>    drivers/net/fec_mxc.h |  4 +++
>>>    2 files changed, 63 insertions(+), 15 deletions(-)
>>>
>>> diff --git a/drivers/net/fec_mxc.c b/drivers/net/fec_mxc.c index
>>> 080dbcf7db..9362aa0d05 100644
>>> --- a/drivers/net/fec_mxc.c
>>> +++ b/drivers/net/fec_mxc.c
>>> @@ -125,28 +125,29 @@ static int fec_mdio_read(struct ethernet_regs
>>> *eth, uint8_t phyaddr,
>>>
>>>    static int fec_get_clk_rate(void *udev, int idx)
>>>    {
>>> -#if IS_ENABLED(CONFIG_IMX8)
>>>    	struct fec_priv *fec;
>>>    	struct udevice *dev;
>>>    	int ret;
>>>
>>> -	dev = udev;
>>> -	if (!dev) {
>>> -		ret = uclass_get_device(UCLASS_ETH, idx, &dev);
>>> -		if (ret < 0) {
>>> -			debug("Can't get FEC udev: %d\n", ret);
>>> -			return ret;
>>> +	if (IS_ENABLED(CONFIG_IMX8) ||
>>> +	    (IS_ENABLED(CONFIG_IMX8M) &&
>> IS_ENABLED(CONFIG_CLK_CCF))) {
>>
>> Can't we just drop the IS_ENABLED(CONFIG_IMX8M)? Otherwise we always
>> need to touch this code when other SoCs will start using CCF.
> 
> ok.
> 
>>
>> Also can you use CONFIG_IS_ENABLED(CLK_CCF) instead of
>> IS_ENABLED(CONFIG_CLK_CCF), so we can detect the config options for SPL
>> and non-SPL separately?
> 
> FEC will not be used in SPL stage, so I not use CONFIG_IS_ENABLED.
> But it does not hurt using IS_ENABLED, change in v2.
> 
> Regards,
> Peng.
> 
>>
>>> +		dev = udev;
>>> +		if (!dev) {
>>> +			ret = uclass_get_device(UCLASS_ETH, idx, &dev);
>>> +			if (ret < 0) {
>>> +				debug("Can't get FEC udev: %d\n", ret);
>>> +				return ret;
>>> +			}
>>>    		}
>>> -	}
>>>
>>> -	fec = dev_get_priv(dev);
>>> -	if (fec)
>>> -		return fec->clk_rate;
>>> +		fec = dev_get_priv(dev);
>>> +		if (fec)
>>> +			return fec->clk_rate;
>>>
>>> -	return -EINVAL;
>>> -#else
>>> -	return imx_get_fecclk();
>>> -#endif
>>> +		return -EINVAL;
>>> +	} else {
>>> +		return imx_get_fecclk();
>>> +	}
>>>    }
>>>
>>>    static void fec_mii_setspeed(struct ethernet_regs *eth) @@ -1335,6
>>> +1336,49 @@ static int fecmxc_probe(struct udevice *dev)
>>>    			return ret;
>>>    		}
>>>
>>> +		priv->clk_rate = clk_get_rate(&priv->ipg_clk);
>>> +	} else if (IS_ENABLED(CONFIG_IMX8M) &&
>> IS_ENABLED(CONFIG_CLK_CCF)) {
>>
>> Same questions here as above.
>>
>>> +		ret = clk_get_by_name(dev, "ipg", &priv->ipg_clk);
>>> +		if (ret < 0) {
>>> +			debug("Can't get FEC ipg clk: %d\n", ret);
>>> +			return ret;
>>> +		} else {
>>
>> You can drop the else branches here and below as the code returns before it
>> will be evaluated.

I think you missed this comment for your v2.

>>
>>> +			ret = clk_enable(&priv->ipg_clk);
>>> +			if(ret)
>>> +				return ret;
>>> +		}
>>> +
>>> +		ret = clk_get_by_name(dev, "ipg", &priv->ahb_clk);
>>
>> This should be "ahb", not "ipg".

And this one, too.

>>
>>> +		if (ret < 0) {
>>> +			debug("Can't get FEC ahb clk: %d\n", ret);
>>> +			return ret;
>>> +		} else {
>>> +			ret = clk_enable(&priv->ahb_clk);
>>> +			if (ret)
>>> +				return ret;
>>> +		}
>>> +
>>> +		ret = clk_get_by_name(dev, "enet_out", &priv->clk_enet_out);
>>> +		if (!ret) {
>>> +			ret = clk_enable(&priv->clk_enet_out);
>>> +			if (ret)
>>> +				return ret;
>>> +		}
>>> +
>>> +		ret = clk_get_by_name(dev, "enet_clk_ref", &priv->clk_ref);
>>> +		if (!ret) {
>>> +			ret = clk_enable(&priv->clk_ref);
>>> +			if (ret)
>>> +				return ret;
>>> +		}
>>> +
>>> +		ret = clk_get_by_name(dev, "ptp", &priv->clk_ptp);
>>> +		if (!ret) {
>>> +			ret = clk_enable(&priv->clk_ptp);
>>> +			if (ret)
>>> +				return ret;
>>> +		}
>>> +
>>>    		priv->clk_rate = clk_get_rate(&priv->ipg_clk);
>>>    	}
>>>
>>> diff --git a/drivers/net/fec_mxc.h b/drivers/net/fec_mxc.h index
>>> e5f2dd75c5..723b06a651 100644
>>> --- a/drivers/net/fec_mxc.h
>>> +++ b/drivers/net/fec_mxc.h
>>> @@ -264,6 +264,10 @@ struct fec_priv {
>>>    	u32 interface;
>>>    #endif
>>>    	struct clk ipg_clk;
>>> +	struct clk ahb_clk;
>>> +	struct clk clk_enet_out;
>>> +	struct clk clk_ref;
>>> +	struct clk clk_ptp;
>>>    	u32 clk_rate;
>>>    };
>>>
>>>


More information about the U-Boot mailing list