[U-Boot] [RESEND PATCH v2 12/13] davinci: omapl138-lcdk: enable driver-model in SPL

[Rizvi, Mohammad Faiz Abbas]

Hi Barotz,

On 10/25/2019 9:40 PM, Bartosz Golaszewski wrote:
> czw., 26 wrz 2019 o 01:21 Faiz Abbas <faiz_abbas at ti.com> napisał(a):
>>
>> Hi,
>>
>> On 29/07/19 12:28 PM, Bartosz Golaszewski wrote:
>>> From: Bartosz Golaszewski <bgolaszewski at baylibre.com>
>>>
>>> Enable CONFIG_SPL_DM and enable the driver model for serial by defining
>>> an appropriate device in the board file for da850-lcdk.
>>>
>>
>> This breaks booting from MMC on omapl138_lcdk. You didn't add a
>> U_BOOT_DEVICE for the mmc node.
>>
>> Thanks,
>> Faiz
> 
> Just letting you know I haven't forgotten about this. I finally got
> some time to work on it this week, but it turned out to be
> non-trivial, as for some reason the set_cmd mmc callback is not being
> properly assigned in SPL with driver-model and I couldn't find out why
> so far.

I will try to look at it as well.

 Next week I'm at ELCE, but I'll be back at it on Thursday.

I'm at ELC as well. Will be nice to meet up with you and discuss this if
you want.

Thanks,
Faiz