[U-Boot] [RESEND PATCH v2 12/13] davinci: omapl138-lcdk: enable driver-model in SPL

[Bartosz Golaszewski]

pt., 25 paź 2019 o 19:25 Rizvi, Mohammad Faiz Abbas
<faiz_abbas at ti.com> napisał(a):
>
> Hi Barotz,
>

It's Bartosz - it's literally on the next line of the e-mail too. :)

> On 10/25/2019 9:40 PM, Bartosz Golaszewski wrote:
> > czw., 26 wrz 2019 o 01:21 Faiz Abbas <faiz_abbas at ti.com> napisał(a):
> >>
> >> Hi,
> >>
> >> On 29/07/19 12:28 PM, Bartosz Golaszewski wrote:
> >>> From: Bartosz Golaszewski <bgolaszewski at baylibre.com>
> >>>
> >>> Enable CONFIG_SPL_DM and enable the driver model for serial by defining
> >>> an appropriate device in the board file for da850-lcdk.
> >>>
> >>
> >> This breaks booting from MMC on omapl138_lcdk. You didn't add a
> >> U_BOOT_DEVICE for the mmc node.
> >>
> >> Thanks,
> >> Faiz
> >
> > Just letting you know I haven't forgotten about this. I finally got
> > some time to work on it this week, but it turned out to be
> > non-trivial, as for some reason the set_cmd mmc callback is not being
> > properly assigned in SPL with driver-model and I couldn't find out why
> > so far.
>
> I will try to look at it as well.
>
>  Next week I'm at ELCE, but I'll be back at it on Thursday.
>
> I'm at ELC as well. Will be nice to meet up with you and discuss this if
> you want.
>

Sure, I'll be doing a talk on Wednesday, may be a good time to catch
me afterwards.

Bartosz

> Thanks,
> Faiz
>
>
>